- 您現在的位置：買賣IC網 > PDF目錄1922 > FT232BL-REEL (FTDI, Future Technology Devices International Ltd)IC USB FS SERIAL UART 32-LQFP PDF資料下載
參數資料
| 型號： | FT232BL-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 33/34頁 |
| 文件大小： | 0K |
| 描述： | IC USB FS SERIAL UART 32-LQFP |
| 產品培訓模塊： | USB Introduction |
| 標準包裝： | 1 |
| 系列： | USBmadeEZ-UART |
| 通道數： | 1，UART |
| FIFO's： | 256 字節 |
| 規程： | RS232，RS422，RS485 |
| 電源電壓： | 4.35V ~ 5.25V |
| 帶自動流量控制功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-LQFP |
| 供應商設備封裝： | 32-LQFP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 其它名稱： | 768-1009-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁
Copyright 2011 Future Technology Devices International Limited
8
Document No.: FT_000329
FT232BL
/BQ USB UART IC Datasheet Version 2.2
Clearance No.: FTDI#
171
3.3 LQFP and QFN Package Pin Out Description
Pin No.
Name
Type
Description
7
USBDP
I/O
USB Data Signal Plus ( Requires 1.5k pull-up to 3V3OUT or RSTOUT# )
8
USBDM
I/O
USB Data Signal Minus
Table 3.1 USB Interface Group
Pin No.
Name
Type
Description
13
VCCIO
PWR
+3.0 volt to +5.25 volt VCC to the UART interface pins 10...12, 14...16 and
18...25. When interfacing with 3.3V external logic in a bus powered design connect
VCCIO to a 3.3V supply generated from the USB bus. When interfacing with 3.3V
external logic in a self powered design connect VCCIO to the 3.3V supply of the
external logic. Otherwise connect to VCC to drive out at 5V CMOS level.
9,17
GND
PWR
Device ground supply pins
6
3V3OUT
Output
3.3 volt Output from the integrated LDO regulator This pin should be decoupled to
GND using a 33nF ceramic capacitor in close proximity to the device pin. Its prime
purpose is to provide the internal 3.3V supply to the USB transceiver cell and the
RSTOUT# pin. A small amount of current (<= 5mA) can be drawn from this pin to
power external 3.3v logic if required.
3,26
VCC
PWR
+4.35 volt to +5.25 volt VCC to the device core, LDO and non-UART interface pins
30
AVCC
PWR
Device analogue power supply for internal x8 clock multiplier
29
AGND
PWR
Device analogue ground supply for internal x8 clock multiplier
Table 3.2 Power and Ground Group
Pin No.
Name
Type
Description
4
RESET#
Input
Active low reset pin. This can be used by an external device to reset the FT232B.
If not required can be left unconnected, or pulled up to VCC.
5
RSTOUT#
Output
Output of the internal Reset Generator. Stays high impedance for ~ 5ms after
VCC > 3.5V and the internal clock starts up, and then clamps its output to the
3.3v output of the internal regulator. Taking RESET# low will also force RSTOUT#
to drive low. RSTOUT# is NOT affected by a USB Bus Reset
12
TXLED#
O.C
LED Drive – Pulses Low when Transmitting Data via USB
11
RXLED#
O.C
LED Drive – Pulses Low when Receiving Data via USB
27
XTIN
Input
Input to 6MHz Crystal Oscillator Cell. This pin can also be driven by an external
6MHz clock if required. Note: Switching threshold of this pin is VCC/2, so if driving
from an external source, the source must be driving at 5V CMOS level or AC-
coupled to centre around VCC/2.
28
XTOUT
Output
Output from 6MHz Crystal Oscillator Cell. XTOUT stops oscillating during USB
suspend, so take care if using this signal to clock external logic.
31
TEST
Input
Puts the device into IC test mode. Must be tied to GND for normal operation,
otherwise the device will appear to fail.
Table 3.3 Miscellaneous Signal Group
相關PDF資料 |
PDF描述 |
|---|---|
| FT232HL-REEL | IC HS USB TO UART/FIFO 48LQFP |
| FT232RL-REEL | IC USB FS SERIAL UART 28-SSOP |
| FT245BL-REEL | IC USB FS PARALLEL FIFO 32-LQFP |
| FT245RL-REEL | IC USB TO PARALLEL FIFO 28-SSOP |
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT232BL-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 128Byte FIFO 5V 32-Pin LQFP Tray |
| FT232BM | 功能描述:UART 接口集成電路 Obsolete FT232BL RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| FT232BQ | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART ( USB - Serial) I.C. |
| FT232BQ-REEL | 功能描述:USB 接口集成電路 USB to Serial UART IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT232HL | 制造商:FTDI 制造商全稱:FTDI 功能描述:FT232H Single Channel Hi-Speed USB to Multipurpose UART/FIFO IC |
發布緊急采購，3分鐘左右您將得到回復。