- 您現在的位置：買賣IC網 > PDF目錄67592 > FSQ0765RQ (FAIRCHILD SEMICONDUCTOR CORP) 3.92 A SWITCHING CONTROLLER, 75.8 kHz SWITCHING FREQ-MAX, ZFM6 PDF資料下載
參數資料
| 型號： | FSQ0765RQ |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 3.92 A SWITCHING CONTROLLER, 75.8 kHz SWITCHING FREQ-MAX, ZFM6 |
| 封裝： | ROHS COMPLIANT, TO-220F, 6 PIN |
| 文件頁數： | 9/19頁 |
| 文件大?。?/td> | 3321K |
| 代理商： | FSQ0765RQ |
F
S
Q0
765RQ
—
Green
-Mode
Farich
ild
P
o
we
rSw
itch
(FPS)
for
Quasi
-Resonant
Operatio
n
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FSQ0765RQ Rev. 1.0.1
17
PCB Layout Guide
Due to the combined scheme, FPS shows better noise
immunity than conventional PWM controller and
MOSFET discrete solution. Further more are internal
drain current sense eliminates the possibility of noise
generation caused by a sensing resistor. There are some
recommendations for PCB layout to enhance noise
immunity and suppress natural noise inevitable in power-
handling components.
There are typically two grounds in the conventional
SMPS: power ground and signal ground. The power
ground is the ground for primary input voltage and
power, while the signal ground is ground for PWM
controller. In FPS, those two grounds share the same
pin, GND. Normally the separate grounds do not share
the same trace and meet only at one point, the GND pin.
More, wider patterns for both grounds are good for large
currents by decreasing resistance.
Capacitors at the VCC and FB pins should be as close
as possible to the corresponding pins to avoid noise from
the switching device. Sometimes Mylar or ceramic
capacitors with electrolytic for VCC are better for smooth
operation. The ground of these capacitors needs to
connect to the signal ground (not power ground).
The cathode of the snubber diode should be close to the
drain pin to minimize stray inductance. The Y-capacitor
between primary and secondary should be directly
connected to the power ground of DC link to maximize
surge immunity.
Because the voltage range of feedback and sync line is
small, it is affected by the noise of the drain pin. Those
traces should not draw across or close to the drain line.
When the heat sink is connected to the ground, it should
be connected to the power ground. If possible, avoid
using jumper wires for power ground and drain.
Mylar is a registered trademark of DuPont Teijin Films.
Figure 37. Recommended PCB Layout
相關PDF資料 |
PDF描述 |
|---|---|
| FUSION878A | COLOR SIGNAL DECODER, PQFP128 |
| FVXO-HC53BR-FREQ | VCXO, CLOCK, 0.75 MHz - 250 MHz, HCMOS OUTPUT |
| FVXO-HC72BR-FREQ | VCXO, CLOCK, 0.75 MHz - 180 MHz, HCMOS OUTPUT |
| FVXO-HC73B-FREQ | VCXO, CLOCK, 0.75 MHz - 250 MHz, HCMOS OUTPUT |
| FVXO-LC52BR-FREQ | VCXO, CLOCK, 0.75 MHz - 1000 MHz, LVDS OUTPUT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FSQ0765RQLDTU | 功能描述:電源開關 IC - 配電 SMPS Power switch (QRC) 7A 650V RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| FSQ0765RQUDTU | 功能描述:電源開關 IC - 配電 SMPS Power SW (QRC) 7A 650V RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| FSQ0765RQWDTU | 功能描述:電源開關 IC - 配電 SMPS Power Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| FSQ0765RS | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Green-Mode Fairchild Power Switch (FPS) for Quasi-Resonant Operation - Low EMI and High Efficiency |
| FSQ0765RSLDTU | 功能描述:電源開關 IC - 配電 SMPS Power switch (QRC) 7A 650V RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。