- 您現在的位置：買賣IC網 > PDF目錄67506 > FND850-12DRG (POWER-ONE INC) 1-OUTPUT 12 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | FND850-12DRG |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 12 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT PACKAGE-26 |
| 文件頁數： | 5/11頁 |
| 文件大小： | 825K |
| 代理商： | FND850-12DRG |
MCD10096 Rev. 1.6, 23-Jul-10
Page 3 of 11
www.power-one.com
FND850-12DRG Front-End Preliminary Data Sheet
DC Input, 12V Output, 850 Watts
Interface Signals and Internal Protection
Parameter
Conditions/Description
Min.
Nom.
Max.
Units
Overvoltage Protection
Latch-style overvoltage protection.
Output adjusted to 12V:
Output adjusted to 7V:
14.36
8.37
15.65
9.13
V
Overcurrent Protection
1
Current limit.
12V output (Vin = 44 to 75V)
12V output (Vin = 36 to 44V)
Standby output:
74
61
1.1
78
64
1.3
85
70
1.5
A
Short-Circuit Protection
Power supply to recover when short is removed.
Overtemperature/
Fan Failure Warning
1
12V output will shut down in the event of an
overtemperature condition or blocked fan rotor.
Supply's fan and Vaux are active. Power
supply will recover when OT condition is
removed. Amber OT LED will turn ON to
indicate fault condition.
OT/Fan Fail is an open-collector signal with
20-mA pull-down. High signal indicates a
normal operating condition. Output will go low
at least 100 ms before OT condition shuts down
the power supply. An amber light indicates fan
failure.
DC OK
1
TTL open-collector signal with active 20-mA
pull-down. Represents percent of nominal set
output voltage where signal is OK. Outside of
this percentage, a signal high condition
indicates an output which is out of tolerance.
Green DC OK LED on front panel indicates
normal operation.
90
110
%
Input Power Fail
Warning
1
TTL open-collector signal with active 20-mA
pull-down. High indicates an input power fail
(outside 36-75 VDC). Power Fail Warning will
turn OFF green INPUT OK LED. Represents
the time after warning signal before Vout drops
to 95% due to loss of input power.
4
ms
Power Supply Present
Signal
1
Resistance of connection to logic ground which
allows user to determine if power supply is
present.
10
Current Share
Main output only. Difference in current between
two supplies (IΔ < 5% Isum - nom)
7.1
A
Remote Sense
Total voltage compensation for cable losses
with respect to the main output.
0.5
V
Output Enable
Open circuit or logic high from ENA pin to Vo1
RTN shuts OFF Vo1; Vaux and fan are
operational. Logic low (2 mA sink capability) or
jumper will turn ON Vo1 within 100 ms. Open
circuit voltage on enable pin is 3.3 VDC.
Externally applied voltage to the enable pin
should NOT exceed 7 VDC. Signal is referred
to as Logic Return (LRTN).
1 Also available on I2C data line.
相關PDF資料 |
PDF描述 |
|---|---|
| FND850-12RG | DC-DC REG PWR SUPPLY MODULE |
| FNP1800-12G | AC-DC PWR FACTOR CORR MODULE |
| FNP1500-12G | 1-OUTPUT 1512 W AC-DC PWR FACTOR CORR MODULE |
| FNP1500-48G | 1-OUTPUT 1512 W AC-DC PWR FACTOR CORR MODULE |
| FNP1800-48G | 1-OUTPUT 1812 W AC-DC PWR FACTOR CORR MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FND850-12RG | 功能描述:線性和開關式電源 Front End 850W (12V) DC input RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| FND-9441R02G01G01B01BW | 制造商:FORGE EUROPA 功能描述:LED DISPLAY RGB DOT MATRIX |
| FNDCCX002S | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:CONTROL CABLE 2M |
| FND-CCX002S | 功能描述:光學開關（反射型，光電晶體管輸出） FNDX General cntrl cable RoHS:否 制造商:Fairchild Semiconductor 感應距離:1 mm 輸出設備:Phototransistor 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電壓:1.2 V 反向電壓:5 V 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格:SMD/SMT 封裝:Reel |
| FNDDF1210T-250A | 制造商:Pentair Technical Products / Hoffman 功能描述:TERMINAL FEMALE DISCONNECT 0.25IN YELLOW 制造商:HOFFMAN PRODUCTS 功能描述:TERMINAL FEMALE DISCONNECT 0.25IN YELLOW 制造商:Pentair Technical Products / Hoffman 功能描述:TERMINAL FEMALE DISCONNECT 0.25IN YELLOW; Connector Type:Female Disconnect; Series:-; Insulator Color:Yellow; Termination Method:Crimp; Stud/Tab Size:0.25" x 0.032"; Wire Size AWG Min:12AWG; Wire Size AWG Max:10AWG; Tab Width:0.250" |
發布緊急采購，3分鐘左右您將得到回復。