- 您現在的位置：買賣IC網 > PDF目錄67412 > FAN4803CSX-2 (FAIRCHILD SEMICONDUCTOR CORP) 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 134 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | FAN4803CSX-2 |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 134 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | SOIC-8 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 131K |
| 代理商： | FAN4803CSX-2 |
PRODUCT SPECIFICATION
FAN4803
REV. 1.2.0 6/21/01
5
GND
GND is the return point for all circuits associated with
this part. Note: a high-quality, low impedance ground is
critical to the proper operation of the IC. High frequency
grounding techniques should be used.
Power Factor Correction
Power factor correction makes a nonlinear load look like a
resistive load to the AC line. For a resistor, the current drawn
from the line is in phase with, and proportional to, the line
voltage. This is dened as a unity power factor is (one). A
common class of nonlinear load is the input of a most power
supplies, which use a bridge rectier and capacitive input l-
ter fed from the line. Peak-charging effect, which occurs on
the input lter capacitor in such a supply, causes brief high-
amplitude pulses of current to ow from the power line,
rather than a sinusoidal current in phase with the line volt-
age. Such a supply presents a power factor to the line of less
than one (another way to state this is that it causes signicant
current harmonics to appear at its input). If the input current
drawn by such a supply (or any other nonlinear load) can be
made to follow the input voltage in instantaneous amplitude,
it will appear resistive to the AC line and a unity power factor
will be achieved.
To hold the input current draw of a device drawing power
from the AC line in phase with, and proportional to, the input
voltage, a way must be found to prevent that device from
loading the line except in proportion to the instantaneous line
voltage. The PFC section of the FAN4803 uses a boost-
mode DC-DC converter to accomplish this. The input to the
converter is the full wave rectied AC line voltage. No lter-
ing is applied following the bridge rectier, so the input
voltage to the boost converter ranges, at twice line frequency,
from zero volts to the peak value of the AC input and back to
zero. By forcing the boost converter to meet two simulta-
neous conditions, it is possible to ensure that the current that
the converter draws from the power line matches the instan-
taneous line voltage. One of these conditions is that the
output voltage of the boost converter must be set higher than
the peak value of the line voltage. A commonly used value is
385VDC, to allow for a high line of 270VACRMS. The other
condition is that the current that the converter is allowed to
draw from the line at any given instant must be proportional
to the line voltage.
Since the boost converter topology in the FAN4803 PFC is
of the current-averaging type, no slope compensation is
required.
Leading/Trailing Modulation
Conventional Pulse Width Modulation (PWM) techniques
employ trailing edge modulation in which the switch will
turn ON right after the trailing edge of the system clock.
The error amplier output voltage is then compared with the
modulating ramp. When the modulating ramp reaches the
level of the error amplier output voltage, the switch will be
turned OFF. When the switch is ON, the inductor current will
ramp up. The effective duty cycle of the trailing edge modu-
lation is determined during the ON time of the switch. Figure
2 shows a typical trailing edge control scheme.
Figure 2. Typical Trailing Edge Control Scheme.
RAMP
VEAO
TIME
VSW1
TIME
REF
EA
–
+
–
+
OSC
DFF
R
D
Q
CLK
U1
RAMP
CLK
U4
U3
C1
RL
I4
SW2
SW1
+
DC
I1
I2
I3
VIN
L1
U2
相關PDF資料 |
PDF描述 |
|---|---|
| FAN4803CSX-1 | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 67 kHz SWITCHING FREQ-MAX, PDSO8 |
| FAN5019MTCX_NL | SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO28 |
| FAN5037MX_NL | SWITCHING CONTROLLER, PDSO8 |
| FAN5037M_NL | SWITCHING CONTROLLER, PDSO8 |
| FAN5061M | SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FAN480X | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:PFC+PWM Combination Controller |
| FAN4810 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Power Factor Correction Controller |
| FAN4810EVAL | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Power Factor Controller |
| FAN4810M | 功能描述:功率因數校正 IC PFC Preregulator RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| FAN4810M_Q | 功能描述:功率因數校正 IC PFC Preregulator RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。