- 您現在的位置：買賣IC網 > PDF目錄67412 > FAN4802SNY (FAIRCHILD SEMICONDUCTOR CORP) 0.5 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 268 kHz SWITCHING FREQ-MAX, DIP16 PDF資料下載
參數資料
| 型號： | FAN4802SNY |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.5 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 268 kHz SWITCHING FREQ-MAX, DIP16 |
| 封裝： | 0.300 INCH, GREEN, MS-001BB, DIP-16 |
| 文件頁數： | 8/19頁 |
| 文件大?。?/td> | 577K |
| 代理商： | FAN4802SNY |
2010 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FAN4800AS/CS/01S/02S Rev. 1.0.1
16
FA
N
4800A
S/C
S
/01S/02S
—
PFC/PWM
Controller
Combination
PWM Control (RAMP)
When the PWM section is used in current mode, RAMP
is generally used as the sampling point for a voltage,
representing the current in the primary of the PWM’s
output transformer. The voltage is derived either from a
current-sensing resistor or a current transformer. In
voltage mode, RAMP is the input for a ramp voltage
generated by a second set of timing components
(RRAMP, CRAMP) that have a minimum value of 0V and a
peak value of approximately 6V. In voltage mode,
feedforward from the PFC output bus is an excellent
way to derive the timing ramp for the PWM stage.
Generating VDD
After turning on the FAN4800AS/CS/01S/02S at 11V,
the operating voltage can vary from 9.3V to 28V. The
threshold voltage of the VDD OVP comparator is 28V
and its hysteresis is 1V. When VDD reaches 28V, OPFC
is LOW and the PWM section is not disturbed. There
are two ways to generate VDD: use auxiliary power
supply around 15V or use bootstrap winding to self-bias
the FAN4800AS/CS/01S/02S system. The bootstrap
winding can be taped from the PFC boost choke or the
transformer of the DC-to-DC stage.
Leading/Trailing Edge Modulation
Conventional PWM techniques employ trailing-edge
modulation, in which the switch turns on right after the
trailing edge of the system clock. The error amplifier
output is then compared with the modulating ramp up.
The effective duty cycle of the trailing-edge modulation
is determined during the on-time of the switch.
In the case of leading-edge modulation, the switch is
turned off exactly at the leading edge of the system
clock. When the modulating ramp reaches the level of
the error amplifier output voltage, the switch is turned
on. The effective duty-cycle of the leading-edge
modulation is determined during off-time of the switch.
相關PDF資料 |
PDF描述 |
|---|---|
| FAN4803CSX-2 | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 134 kHz SWITCHING FREQ-MAX, PDSO8 |
| FAN4803CSX-1 | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, 67 kHz SWITCHING FREQ-MAX, PDSO8 |
| FAN5019MTCX_NL | SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO28 |
| FAN5037MX_NL | SWITCHING CONTROLLER, PDSO8 |
| FAN5037M_NL | SWITCHING CONTROLLER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FAN4803 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:8-Pin PFC and PWM Controller Combo |
| FAN4803CP1 | 功能描述:功率因數校正 IC PFC/PWM Controller Combo RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| FAN4803CP-1 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:8-Pin PFC and PWM Controller Combo |
| FAN4803CP1_Q | 功能描述:功率因數校正 IC PFC/PWM Controller Combo RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| FAN4803CP2 | 功能描述:功率因數校正 IC PFC/PWM Controller Combo RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。