- 您現在的位置：買賣IC網 > PDF目錄362685 > EM78P5830AP (ELAN Microelctronics Corp .) 8-BIT MICRO-CONTROLLER PDF資料下載
參數資料
| 型號： | EM78P5830AP |
| 廠商： | ELAN Microelctronics Corp . |
| 英文描述： | 8-BIT MICRO-CONTROLLER |
| 中文描述： | 8位微控制器 |
| 文件頁數： | 30/43頁 |
| 文件大小： | 396K |
| 代理商： | EM78P5830AP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
EM785830AA
8-bit Micro-controller
__________________________________________________________________________________________________________________________________________________________________
* This specification is subject to be changed without notice.
12/1/2004 V1.6
VII.5 RESET
The RESET can be caused by
(1) Power on reset
(2) WDT timeout. (if enabled and in GREEN or NORMAL mode)
(3) /RESET pin pull low
Once the RESET occurs, the following functions are performed.
The oscillator is running, or will be started.
The Program Counter (R2) is set to all "0".
When power on, the upper 3 bits of R3 and the upper 2 bits of R4 are cleared.
The Watchdog timer and prescaler counter are cleared.
The Watchdog timer is disabled.
The CONT register is set to all "1"
The other register (bit 7 ~ bit 0) default values are as follows.
Operation registers :
Address
R register
PAGE0
PAGE1
0x4
00xxxxxx
0x5
xxxx0000
xxxx0000
0x6
xxxxxxxx
xxxxxxxx
0x7
xxxxxxxx
xxxx0000
0x8
xxxxxxxx
00000000
0x9
xxxxxxxx
xxxxxxxx
0xA
00011xx0
11111111
0xB
xxxxxxxx
xxxxxxxx
0xC
xxxxxxxx
00000000
0xD
xxxxx000
00000000
0xE
00000000
0xF
00000000
VII.6 Wake-up
The controller provided sleep mode for power saving :
SLEEP mode, RA(7) = 0 + "SLEP" instruction
The controller will turn off all the CPU and crystal. Other circuit with power control like key tone control or
PLL control (which has enable register), user has to turn it off by software.
Wake-up from SLEEP mode
(1) WDT time out
(2) External interrupt
(3) /RESET pull low
All these cases will reset controller , and run the program at address zero. The status just like the power on reset.
VII.7 Interrupt
RF is the interrupt status register which records the interrupt request in flag bit. IOCF is the interrupt mask
register. Global interrupt is enabled by ENI instruction and is disabled by DISI instruction. When one of the
interrupts (when enabled) generated, will cause the next instruction to be fetched from address 008H. Once in the
interrupt service routine, the source of the interrupt can be determined by polling the flag bits in the RF register.
The interrupt flag bit must be cleared in software before leaving the interrupt service routine and enabling
interrupts to avoid recursive interrupts.
R register
R register
PAGE2
00000000
xxxxxxxx
0x000000
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
R register
PAGE3
00000000
00000000
xxxxxx00
00000000
00000000
xxxxxx00
00000000
IOC register
PAGE0
111x0000
11111111
11111111
11111111
11111111
xxxxxxxx
11111111
11111111
xxxxxxxx
0000xxxx
00000000
IOC register
PAGE1
00000000
00000000
00000000
00000000
x0xx0xx
000000x0
00000000
00000000
xxxxxxxx
相關PDF資料 |
PDF描述 |
|---|---|
| EM78P5830DQ | 8-BIT MICRO-CONTROLLER |
| EM785840 | 8-BIT MICRO-CONTROLLER |
| EM785840M | 8-BIT MICRO-CONTROLLER |
| EM785840P | 8-BIT MICRO-CONTROLLER |
| EM785841 | 8-BIT MICRO-CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EM7A8620 | 制造商:EMC 制造商全稱:ELAN Microelectronics Corp 功能描述:Voice over IP |
| EM7G | 制造商:GULFSEMI 制造商全稱:Gulf Semiconductor 功能描述:ULTRAFAST EFFICIENT PLASTIC SILICON RECTIFIER VOLTAGE： 1000V CURRENT： 1.0A |
| EM800 | 制造商:EDI 制造商全稱:Electronic devices inc. 功能描述:HIGH VOLTAGE HIGH CURRENT MINIATURE RECTIFIERS |
| EM8000EHP | 制造商:JDSU 制造商全稱:JDS Uniphase Corporation 功能描述:The industrya??s most compact 100 G test solution |
| EM800-DCM | 制造商:MRV 制造商全稱:MRV 功能描述:LambdaDriver Dispersion Compensation Module (EM800/1600-DCM and DCMD) |
發布緊急采購，3分鐘左右您將得到回復。