參數資料
型號: EM4223V2WS7E
廠商: EM Microelectronic
英文描述: Read-only UHF Radio Frequency Identification Device
中文描述: 只讀超高頻射頻識別設備
文件頁數: 15/29頁
文件大?。?/td> 437K
代理商: EM4223V2WS7E
R
EM4223
Copyright
2005, EM Microelectronic-Marin SA
15
www.emmicroelectronic.com
5. FORWARD LINK ENCODING - READER TO
TRANSPONDER
Commands and data are received from the Reader,
encoded by means of Pulse Interval Encoding. The
Reader transmits pulses in the form of dips in its carrier
wave. The intervals between dips convey information in
accordance with the following description.
The Transponder responds to transmissions by the
Reader as described herein.
Carrier modulation pulses
The data transmission from the Reader to the
Transponder is achieved by modulating the carrier
amplitude (ASK). The data coding is performed by
generating pulses at variable time intervals. The duration
of the interval between two successive pulses carries the
data coding information. This is known as Pulse Interval
Encoding, (PIE). The Transponder measures the inter-
pulse time on the high to low transitions (falling) edges of
the pulse as shown in
58H58H
Fig. 9
Basic time interval – definition of “Tari”
The time “Tari” specifies the period in microseconds
between two falling edges representing the symbol “0”.
The word “Tari” is an acronym for “Type A Reference
Interval Time” as defined in the ISO18000-6 Type A
specification. The period between the two falling edges
defining each of the other symbols is based on a multiple
of the basic Tari period. The SOF symbol (Start of
Frame) consists of 2 periods, the 1
of which is equal to
One Tari, while the 2
nd
period of the SOF symbol is equal
to 3 Tari. The first part of the SOF symbol is provided to
allow detector circuitry to settle (should this be
necessary). The second part of the SOF symbol is used
as a Calibration period. The received SOF symbol is
used to calibrate the command decoder every time a
command is received. This calibration is used to
establish a pivot to distinguish between subsequent data
‘0’ and data ‘1’ symbols. The pivot point has a value of
1.5Tari and is derived from the 3Tari interval contained in
the 2
part of the SOF symbol. The binary data ‘0’ and
‘1’ are extracted from the incoming data stream by
comparing the inter-pulse interval with a pivot point. If the
interval is less than the pivot, then the binary value is ‘0’
and if it is greater than the pivot then the binary value is
‘1’ (See clause
received by the Transponder, the SOF re-calibrates the
decode counter thereby compensating for any variation
in the Transponder clock frequency due to changes in
RF excitation levels or temperature variations. The circuit
has been designed to accommodate a Transponder
clock frequency variation of ±40% from nominal. The
basic Tari period as transmitted by the Reader is
specified in
60H60H
Table 16 and illustrated in
61H61H
Fig. 9
.
Tari
20 μs
Table 16 - Reference interval timing
59H59H
0). Each time that a new command is
Tolerance
±100 ppm
Tari
M
100%
Fig. 9 - Inter-pulse mechanism
相關PDF資料
PDF描述
EM4223V2WW11 Read-only UHF Radio Frequency Identification Device
EM4223V2WW7E Read-only UHF Radio Frequency Identification Device
EM4223V3WS11E Read-only UHF Radio Frequency Identification Device
EM4223V3WS7 Read-only UHF Radio Frequency Identification Device
EM4223V6WS7E Read-only UHF Radio Frequency Identification Device
相關代理商/技術參數
參數描述
EM4223V2WW11 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:Read-only UHF Radio Frequency Identification Device
EM4223V2WW11E 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:Read-only UHF Radio Frequency Identification Device
EM4223V2WW7 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:Read-only UHF Radio Frequency Identification Device
EM4223V2WW7E 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:Read-only UHF Radio Frequency Identification Device
EM4223V3SP3B 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:Read-only UHF Radio Frequency Identification Device