參數資料
| 型號： | EL8102IWZ-T7 |
| 廠商： | Intersil |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP 500MHZ R-R SGL SOT23-6 |
| 產品培訓模塊： | High Speed Op Amps |
| 標準包裝： | 1 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 600 V/µs |
| 增益帶寬積： | 200MHz |
| -3db帶寬： | 500MHz |
| 電流 - 輸入偏壓： | 6µA |
| 電壓 - 輸入偏移： | 800µV |
| 電流 - 電源： | 5.6mA |
| 電流 - 輸出 / 通道： | 65mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 5 V，±1.5 V ~ 2.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 |
| 供應商設備封裝： | SOT-23-6 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1234 (CN2011-ZH PDF) |
| 其它名稱： | EL8102IWZ-T7DKR |
11
FN7104.7
August 10, 2007
Typical Applications
VIDEO SYNC PULSE REMOVER
Many CMOS analog to digital converters have a parasitic
latch up problem when subjected to negative input voltage
levels. Since the sync tip contains no useful video
information and it is a negative going pulse, we can chop it
off. Figure 30 shows a gain of 2 connections for EL8102,
EL8103. Figure 31 shows the complete input video signal
applied at the input, as well as the output signal with the
negative going sync pulse removed.
MULTIPLEXER
Besides the normal power-down usage, the ENABLE pin of
the EL8102 can be used for multiplexing applications. Figure
32 shows two EL8102 with the outputs tied together, driving
a back terminated 75
Ω video load. A 2V
P-P 2MHz sine wave
is applied to Amp A and a 1VP-P 2MHz sine wave is applied
to Amp B. Figure 33 shows the ENABLE signal and the
resulting output waveform at VOUT. Observe the break-
before-make operation of the multiplexing. Amp A is on and
VIN1 is passed through to the output when the ENABLE
signal is low and turns off in about 25ns when the ENABLE
signal is high. About 200ns later, Amp B turns on and VIN2 is
passed through to the output. The break-before-make
operation ensures that more than one amplifier isn’t trying to
drive the bus at the same time.
SINGLE SUPPLY VIDEO LINE DRIVER
The EL8102 and EL8103 are wideband rail-to-rail output op
amplifiers with large output current, excellent dG, dP, and low
distortion that allow them to drive video signals in low supply
applications. Figure 34 is the single supply non-inverting
video line driver configuration and Figure 35 is the inverting
video line driver configuration. The signal is AC coupled by
C1. R1 and R2 are used to level shift the input and output to
provide the largest output swing. RF and RG set the AC gain.
C2 isolates the virtual ground potential. RT and R3 are the
termination resistors for the line. C1, C2 and C3 are selected
big enough to minimize the droop of the luminance signal.
FIGURE 30. SYNC PULSE REMOVER
5V
1k
VOUT
VIN
75
Ω
+
-
75
Ω
1k
75
Ω
VS+
VS-
FIGURE 31. VIDEO SIGNAL
1V
0.5V
0V
1V
0.5V
0V
M = 10s/DIV
VOUT
VIN
FIGURE 32. TWO TO ONE MULTIPLEXER
+2.5V
1k
2MHz
75
Ω
+
-
1k
75
Ω
-2.5V
VOUT
75
Ω
1V
P-P
B
+2.5V
1k
2MHz
+
-
1k
75
Ω
-2.5V
2VP-P
A
ENABLE
FIGURE 33.
0V
-0.5V
-1.5V
-2.5V
1V
0V
M = 50ns/DIV
A
ENABLE
B
-1V
EL8102, EL8103
相關PDF資料 |
PDF描述 |
|---|---|
| 2-320571-5 | CONN RING TONGUE 18AWG #1/4 |
| 8-36151-1 | CONN RING 22-16AWG #6 PIDG |
| 8-320565-1 | CONN RING 14-16AWG #8 BLUE PIDG |
| 8-36160-1 | CONN RING 16-14AWG #10 PIDG |
| BK/AGX-25 | FUSE 25A 32V FAST AGX 8AG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL8102IWZ-T7A | 功能描述:運算放大器 - 運放 EL8102IWZ 500MHZ R2R AMP RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| EL8103 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:500MHz Rail-to-Rail Amplifiers |
| EL8103IW-T7 | 功能描述:IC OP AMP 500MHZ R-R SOT23-5 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| EL8103IW-T7A | 功能描述:IC OP AMP 500MHZ R-R SOT-23-5 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| EL8103IWZ-T7 | 功能描述:運算放大器 - 運放 EL8103IWZ 500MHZ R2R AMP RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。