參數資料
型號： EL7642ILTZ
廠商： INTERSIL CORP
元件分類： 穩壓器
英文描述： TFT-LCD DC/DC with Integrated Amplifiers
中文描述： 3 A SWITCHING REGULATOR, 1350 kHz SWITCHING FREQ-MAX, QCC32
封裝： 5 X 5 MM, ROHS COMPLIANT, MO-220, TQFN-32
文件頁數： 12/19頁
文件大?。?/td> 493K
代理商： EL7642ILTZ
12
FN7415.1
September 26, 2005
The following table gives typical values (margins are
considered 10%, 3%, 20%, 10% and 15% on V
IN
, V
O
, L, f
S
and I
LMT
:
Input Capacitor
The input capacitor is used to supply the current to the
converter. It is recommended that C
IN
be larger than 10
μ
F.
The reflected ripple voltage will be smaller with larger C
IN
.
The voltage rating of input capacitor should be larger than
maximum input voltage.
Boost Inductor
The boost inductor is a critical part which influences the
output voltage ripple, transient response, and efficiency.
Value of 3.3
μ
H to 10
μ
H inductor is recommended in
applications to fit the internal slope compensation. The
inductor must be able to handle the following average and
peak current:
I
D
–
Rectifier Diode
A high-speed diode is desired due to the high switching
frequency. Schottky diodes are recommended because of
their fast recovery time and low forward voltage. The rectifier
diode must meet the output current and peak inductor
current requirements.
Output Capacitor
The output capacitor supplies the load directly and reduces
the ripple voltage at the output. Output ripple voltage
consists of two components: the voltage drop due to the
inductor ripple current flowing through the ESR of output
capacitor, and the charging and discharging of the output
capacitor.
For low ESR ceramic capacitors, the output ripple is
dominated by the charging and discharging of the output
capacitor. The voltage rating of the output capacitor should
be greater than the maximum output voltage.
NOTE: Capacitors have a voltage coefficient that makes their
effective capacitance drop as the voltage across them increases.
C
OUT
in the equation above assumes the effective value of the
capacitor at a particular voltage and not the manufacturer’s stated
value, measured at zero volts.
Compensation
The EL7640, EL7641, EL7642 can operate in either P mode
or PI mode. Connecting COMP pin directly to V
IN
will enable
P mode; For better load regulation, use PI mode with a
2.2nF capacitor and a 180
resistor in series between
COMP pin and ground. To improve the transient response,
either the resistor value can be increased or the capacitor
value can be reduced, but too high resistor value or too low
capacitor value will reduce loop stability.
Boost Feedback Resistors
As the boost output voltage, V
BOOST
, is reduced below 12V
the effective voltage feedback in the IC increases the ratio of
voltage to current feedback at the summing comparator
because R2 decreases relative to R1. To maintain stable
operation over the complete current range of the IC, the
voltage feedback to the FBB pin should be reduced
proportionally, as V
BOOST
is reduced, by means of a series
resistor-capacitor network (R7 and C7) in parallel with R1,
with a pole frequency (fp) set to approximately 10kHz. for C2
effective = 10μF and 4kHz for C2 (effective) = 30μF.
R7 = ((1/0.1 x R2) – 1/R1)^-1
C7 = 1/(2 x 3.142 x fp x R7)
Linear-Regulator Controllers (V
ON
and V
OFF
)
The EL7640, EL7641, EL7642 include 2 independent
linear-regulator controllers, in which there is one positive
output voltage (V
ON
), and one negative voltage (V
OFF
). The
V
ON
and V
OFF
linear-regulator controller function diagram,
application circuit and waveforms are shown in Figure 19
and Figure 20 respectively.
TABLE 2.
V
IN
(V)
V
O
(V)
L (μH)
f
S
(MHz)
I
OMAX
(mA)
3.3
9
6.8
1.2
898
3.3
12
6.8
1.2
622
3.3
15
6.8
1.2
458
5
9
6.8
1.2
1360
5
12
6.8
1.2
944
5
15
6.8
1.2
694
I
LAVG
-------------
=
I
LPK
I
LAVG
I
L
2
--------
+
=
V
RIPPLE
I
LPK
ESR
V
-----------------------
V
–
O
I
OUT
---------------
1
f
S
----
×
×
+
×
=
EL7640, EL7641, EL7642
相關PDF資料
PDF描述
EL7640ILTZ-T13 TFT-LCD DC/DC with Integrated Amplifiers
EL7641ILTZ-T13 TFT-LCD DC/DC with Integrated Amplifiers
EL7642ILTZ-T13 TFT-LCD DC/DC with Integrated Amplifiers
EL7642 TFT-LCD DC/DC with Integrated Amplifiers
EL7761 100V Half Bridge Driver
相關代理商/技術參數
參數描述
EL7642ILTZ-T13 功能描述:直流/直流開關調節器 EL7642ILTZ TFT-LCD D C-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
EL7642ILTZ-T7 功能描述:直流/直流開關調節器 EL7642ILTZ TFT-LCD D C-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
EL7661CN 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC-100V FULL BRIDGE DRIVER
EL7661CS 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MOSFET Driver
EL7761 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:100V Half Bridge Driver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*