- 您現在的位置：買賣IC網 > PDF目錄10841 > EL5624IREZ-T7 (Intersil)IC BUFFER 6XGAMMA 6.8MA 20HTSSOP PDF資料下載
參數資料
| 型號： | EL5624IREZ-T7 |
| 廠商： | Intersil |
| 文件頁數： | 11/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BUFFER 6XGAMMA 6.8MA 20HTSSOP |
| 標準包裝： | 1,000 |
| 應用： | TFT-LCD 面板：伽瑪緩沖器，VCOM 驅動器 |
| 輸出類型： | 滿擺幅 |
| 電路數： | 6 |
| -3db帶寬： | 12MHz |
| 轉換速率： | 15 V/µs |
| 電流 - 電源： | 6.8mA |
| 電流 - 輸出 / 通道： | 140mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 帶卷 (TR) |
9
Description of Operation and Application
Information
Product Description
The EL5524, EL5624, EL5724, and EL5824 are fabricated
using a high voltage CMOS process. They exhibit rail to rail
input and output capability and have very low power
consumption. When driving a load of 10K and 12pF, the
buffers have a -3dB bandwidth of 12MHz and exhibit 18V/s
slew rate. The VCOM amplifier has a -3dB bandwidth of
35MHz and exhibit 80V/s slew rate.
Input, Output, and Supply Voltage Range
The EL5524, EL5624, EL5724, and EL5824 are specified
with a single nominal supply voltage from 5V to 15V or a split
supply with its total range from 5V to 15V. Correct operation
is guaranteed for a supply range from 4.5V to 16.5V.
The input common-mode voltage range of the EL5524,
EL5624, EL5724, and EL5824 extends 500mV beyond the
supply rails. The output swings of the buffers and VCOM
amplifier typically extend to within 100mV of the positive and
negative supply rails with load currents of 5mA. Decreasing
load currents will extend the output voltage even closer to
each supply rails.
Output Phase Reversal
The EL5524, EL5624, EL5724, and EL5824 are immune to
phase reversal as long as the input voltage is limited from
VS- -0.5V to VS+ +0.5V. Although the device's output will not
change phase, the input's overvoltage should be avoided. If
an input voltage exceeds supply voltage by more than 0.6V,
electrostatic protection diode placed in the input stage of the
device begin to conduct and overvoltage damage could
occur.
Choice of Feedback Resistor and Gain Bandwidth
Product for VCOM Amplifier
For applications that require a gain of +1, no feedback
resistor is required. Just short the output pin to the inverting
input pin. For gains greater than +1, the feedback resistor
forms a pole with the parasitic capacitance at the inverting
input. As this pole becomes smaller, the amplifier's phase
margin is reduced. This causes ringing in the time domain
and peaking in the frequency domain. Therefore, RF has
some maximum value that should not be exceeded for
optimum performance. If a large value of RF must be used, a
small capacitor in the few Pico farad range in parallel with RF
can help to reduce the ringing and peaking at the expense of
reducing the bandwidth.
As far as the output stage of the amplifier is concerned, the
output stage is also a gain stage with the load. RF and RG
appear in parallel with RL for gains other than +1. As this
combination gets smaller, the bandwidth falls off.
Consequently, RF also has a minimum value that should not
be exceeded for optimum performance. For gain of +1, RF =
0 is optimum. For the gains other than +1, optimum
response is obtained with RF between 1k to 5k.
The VCOM amplifier has a gain bandwidth product of
20MHz. For gains
≥5, its bandwidth can be predicted by the
following equation:
Output Drive Capability
The EL5524, EL5624, EL5724, and EL5824 do not have
internal short-circuit protection circuitry. The buffers will limit
the short circuit current to ±120mA and the VCOM amplifier
FIGURE 19. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
FIGURE 20. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
Typical Performance Curves (Continued)
JEDEC JESD51-3 LOW EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD
1
0.9
0.6
0.4
0.3
0.2
0.1
0
255075
100
150
AMBIENT TEMPERATURE (°C)
POWER
DISS
IP
A
T
ION
(W)
85
0.8
0.5
0.7
125
909mW
800mW
694mW
833mW
θJA=110°C/W
HTSSOP28
θJA=120°C/W
HTSSOP24
θJA=125°C/W
HTSSOP20
θJA=144°C/W
HTSSOP14
JEDEC JESD51-7 HIGH EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD -
HTSSOP EXPOSED DIEPAD SOLDERED TO
PCB PER JESD51-5
3.5
3
2.5
1.5
1
0.5
0
255075
100
150
AMBIENT TEMPERATURE (°C)
P
O
WER
DIS
S
IP
A
T
ION
(W
)
125
85
2
2.632W
3.333W
3.030W
2.857W
θJA=35°C/W
HTSSOP20
θJA=38°C/W
HTSSOP14
θJA=30°C/W
HTSSOP28
θJA=33°C/W
HTSSOP24
Gain
BW
20MHz
=
×
EL5524, EL5624, EL5724, EL5824
相關PDF資料 |
PDF描述 |
|---|---|
| EL5624IREZ-T13 | IC BUFFER 6XGAMMA 6.8MA 20HTSSOP |
| MAX5442BCUB+T | IC DAC 16BIT 5V SERIAL 10-UMAX |
| EL5624IRE-T7 | IC BUFFER 6XGAMMA 6.8MA 20HTSSOP |
| EL5624IRE-T13 | IC BUFFER 6XGAMMA 6.8MA 20HTSSOP |
| VI-26K-IV-F4 | CONVERTER MOD DC/DC 40V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5625 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Programmable 18-Channel Gamma with 1-Channel VCOM with Reference |
| EL5625ILZ | 功能描述:LCD Gamma緩沖器 EL5625ILZ PROGUFR + VCOM RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5625ILZ-T13 | 功能描述:LCD Gamma緩沖器 EL5625ILZ PROGUFR + VCOM RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5724 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Integrated Buffers with VCOM |
| EL5724IRE | 功能描述:IC INTEGRATED BUFFER 24-HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。