- 您現在的位置：買賣IC網 > PDF目錄1918 > EFM32G280F64 (Energy Micro)MCU 32BIT 64KB FLASH 100-LQFP PDF資料下載
參數資料
| 型號： | EFM32G280F64 |
| 廠商： | Energy Micro |
| 文件頁數： | 45/69頁 |
| 文件大?。?/td> | 0K |
| 描述： | MCU 32BIT 64KB FLASH 100-LQFP |
| 標準包裝： | 1,000 |
| 系列： | Gecko |
| 核心處理器： | ARM? Cortex?-M3 |
| 芯體尺寸： | 32-位 |
| 速度： | 32MHz |
| 連通性： | EBI/EMI，I²C，IrDA，智能卡，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，DMA，POR，PWM，WDT |
| 輸入/輸出數： | 86 |
| 程序存儲器容量： | 64KB（64K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 16K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.8 V ~ 3.8 V |
| 數據轉換器： | A/D 8x12b，D/A 2x12b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 100-LQFP |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | EFM32G280F64-QFP100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁
...the world's most energy friendly microcontrollers
2013-06-28 - EFM32G280FXX - d0006_Rev1.60
5
www.energymicro.com
Slave arbitration and timeouts are also provided to allow implementation of an SMBus compliant system.
The interface provided to software by the I
2C module, allows both fine-grained control of the transmission
process and close to automatic transfers. Automatic recognition of slave addresses is provided in all
energy modes.
2.1.12 Universal Synchronous/Asynchronous Receiver/Transmitter (US-
ART)
The Universal Synchronous Asynchronous serial Receiver and Transmitter (USART) is a very flexible
serial I/O module. It supports full duplex asynchronous UART communication as well as RS-485, SPI,
MicroWire and 3-wire. It can also interface with ISO7816 SmartCards, and IrDA devices.
2.1.13 Pre-Programmed Serial Bootloader
The bootloader presented in application note AN0003 is pre-programmed in the device at factory. Auto-
baud and destructive write are supported. The autobaud feature, interface and commands are described
further in the application note.
2.1.14 Universal Asynchronous Receiver/Transmitter (UART)
The Universal Asynchronous serial Receiver and Transmitter (UART) is a very flexible serial I/O module.
It supports full- and half-duplex asynchronous UART communication.
2.1.15 Low Energy Universal Asynchronous Receiver/Transmitter
(LEUART)
The unique LEUART
TM, the Low Energy UART, is a UART that allows two-way UART communication on
a strict power budget. Only a 32.768 kHz clock is needed to allow UART communication up to 9600 baud/
s. The LEUART includes all necessary hardware support to make asynchronous serial communication
possible with minimum of software intervention and energy consumption.
2.1.16 Timer/Counter (TIMER)
The 16-bit general purpose Timer has 3 compare/capture channels for input capture and compare/Pulse-
Width Modulation (PWM) output. TIMER0 also includes a Dead-Time Insertion module suitable for motor
control applications.
2.1.17 Real Time Counter (RTC)
The Real Time Counter (RTC) contains a 24-bit counter and is clocked either by a 32.768 kHz crystal
oscillator, or a 32.768 kHz RC oscillator. In addition to energy modes EM0 and EM1, the RTC is also
available in EM2. This makes it ideal for keeping track of time since the RTC is enabled in EM2 where
most of the device is powered down.
2.1.18 Low Energy Timer (LETIMER)
The unique LETIMER
TM, the Low Energy Timer, is a 16-bit timer that is available in energy mode EM2
in addition to EM1 and EM0. Because of this, it can be used for timing and output generation when most
of the device is powered down, allowing simple tasks to be performed while the power consumption of
the system is kept at an absolute minimum. The LETIMER can be used to output a variety of waveforms
with minimal software intervention. It is also connected to the Real Time Counter (RTC), and can be
configured to start counting on compare matches from the RTC.
2.1.19 Pulse Counter (PCNT)
The Pulse Counter (PCNT) can be used for counting pulses on a single input or to decode quadrature
encoded inputs. It runs off either the internal LFACLK or the PCNTn_S0IN pin as external clock source.
The module may operate in energy mode EM0 – EM3.
相關PDF資料 |
PDF描述 |
|---|---|
| EFM32G290F64 | MCU 32BIT 64KB FLASH 112-BGA |
| EFM32G840F64 | MCU 32BIT 64KB FLASH 64-QFN |
| EFM32G842F64 | IC MCU 32BIT 64KB FLASH LQFP64 |
| EFM32G880F128 | IC MCU 32BIT 128KB FLASH 100QFP |
| EFM32G890F64 | MCU 32BIT 64KB FLASH 112-BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EFM32G280F64-QFP100 | 制造商:Energy Micro AS 功能描述:MCU, 64K FLASH, USART+UART 3+1, QFP100 - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 64KB FLASH 100LQFP |
| EFM32G280F64-QFP100T | 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, GECKO - Trays |
| EFM32G280F64-QFP100-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 64KB FLASH 100LQFP |
| EFM32G280F64-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 64KB FLASH 100LQFP |
| EFM32-G280-SK-F128 | 制造商:Energy Micro AS 功能描述:MCU CORTEX-M3 EFM32-G280 SAMPLE-PK 制造商:Energy Micro AS 功能描述:EFM32-G280-F128 Sample Kit (2 per) |
發布緊急采購，3分鐘左右您將得到回復。