- 您現在的位置：買賣IC網 > PDF目錄299021 > EE-SPW321-A SPECIALTY OPTOELECTRONIC DEVICE PDF資料下載
參數資料
| 型號： | EE-SPW321-A |
| 元件分類： | 光電元器件 |
| 英文描述： | SPECIALTY OPTOELECTRONIC DEVICE |
| 文件頁數： | 4/5頁 |
| 文件大?。?/td> | 363K |
| 代理商： | EE-SPW321-A |
EE-SPW321/421
4
Safety Precautions
Refer to Warranty and Limitations of Liability.
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Make sure that this product is used within the rated ambient
environment conditions.
● Wiring
Connections
The length of the standard cable is 10 m max. (including the cable
attachment, AWG24 min.). When extending the Sensor wires, use a
wire greater than AWG 22 in diameter and a cable shorter than
100 m. If the cable length exceeds 10 m, the supply voltage applied
at the Sensor terminal will decrease as the impedance of the
extended cable increases and the low level output voltage at the cable
end will increase. Therefore, take voltage fluctuation into account
when extending the Sensor cable.
● Mounting
Tighten the mounting screws to a torque of 0.54 Nm max.
● Adjustment
Aperture Stickers
Two kinds of reticles are attached, the 0.5-mm and the 1.0-mm width
types (total of 4 stickers with slit widths A to D as shown in the
following diagram).
Use these when the sensing object is 2 mm or smaller or when mutual
interference must be reduced.
For each slit of the same type, attach a sticker to the sensing surface
of the emitter and receiver.
Optical Axis Adjustment
(1)Set the Sensor so that the center of the lens in the emitter and
receiver form one line.
(2)Having checked that the Sensor is correctly wired, turn ON the
power. The operation indicator on the amplifier of the emitter will
light. Check to make sure the light goes ON and OFF when an
opaque object is moved in and out between the emitter and
receiver.
(3)Move the emitter (or receiver) up and down, left and right and
secure the emitter (or receiver) in the center of the range of the
operation indicator. Secure the receiver (or emitter) in the same
way after adjustment is complete.
(Unit: mm)
Dimensions
Tolerance class IT16 applies to dimensions in this datasheet unless otherwise specified.
WARNING
Precautions for Correct Use
8.8 mm
4.6 mm
L
Square hole
H
Note: These are pressure sensitive
adhesive-type stickers.
Peel off the seal and stick it on the
lens.
Size L (mm) Size H (mm)
Slit A
0.5
3
Slit B
13
Slit C
30.5
Slit D
31
12
5.8
6
Receiver
Optical axis
Emitter
Indicator window
(Emitter only)
7.5
10.7 (5.5)
2.7
Two, 3.1 dia.
hole
2.5
(3.75)
3
3.2 dia. hole
Two, R1.6
(50)
39
40
(14.5)
2,000
Indicator window
31.5
2
7.5
Vinyl-insulated round cable of 3.5 dia., 3 cores,
(0.14 mm2 with 1.0-dia. insulator); Standard length: 2 m
Vinyl-insulated round cable of 2.4. dia.
2.4 dia. oil-resistant type
33
2
3.2
(7.5)
12
(2.25)
2
L *
Optical axis
* L = 500 mm
(EE-SPW321, EE-SPW421)
L = 1,000 mm
(EE-SPW321-A, EE-SPW421-A)
EE-SPW321
EE-SPW321-A
EE-SPW421
EE-SPW421-A
相關PDF資料 |
PDF描述 |
|---|---|
| EE-SPX303-1 | 13 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT |
| EE-SPX306-W2A | TRANSISTOR OUTPUT OPTOCOUPLER |
| EE-SPY311 | SPECIALTY OPTOELECTRONIC DEVICE |
| EE-SPY412 | SPECIALTY OPTOELECTRONIC DEVICE |
| EE-SX1041 | 5 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH TRANSISTOR OUTPUT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EESPW411 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:PHOTO REC/TRANS/1M DIST/ LT ON 制造商:Omron Electronic Components LLC 功能描述:Proximity Sensor Light ON 100cm 5V to 24V 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:T-BEAM PMS L-ON PMOD 1M SD |
| EE-SPW411 | 功能描述:光學開關（透射型，光電晶體管輸出） TRANS 1 m SNS DIST RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| EESPW421 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:PHOTO REC/TRANS/300MM/LT ON 制造商:Omron Electronic Components LLC 功能描述:Proximity Sensor Optical Light ON NPN 30cm 10.8V to 26.4V 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:T-BEAM PMS SLIM 11.8in SD L-ON |
| EE-SPW421 | 功能描述:光學開關（透射型，光電晶體管輸出） TRANS 30cm SNS DIST RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| EESPW421A | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR LIGHT-ON TRANS 制造商:Omron Electronic Components LLC 功能描述:Proximity Sensor Optical Light ON NPN 30cm 10.8V to 26.4V 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:T-BEAM PMS SLIM 11.8in SD L-ON |
發布緊急采購，3分鐘左右您將得到回復。