- 您現在的位置：買賣IC網 > PDF目錄362598 > Edge749 (Semtech Corporation) Low Power 5V RS232 Dual Driver/Receiver with 0.1?μF Capacitors; Package: SO; No of Pins: 16; Temperature Range: -40?°C to 85?°C PDF資料下載
參數資料
| 型號： | Edge749 |
| 廠商： | Semtech Corporation |
| 元件分類： | 外設及接口 |
| 英文描述： | Low Power 5V RS232 Dual Driver/Receiver with 0.1?μF Capacitors; Package: SO; No of Pins: 16; Temperature Range: -40?°C to 85?°C |
| 中文描述： | 電可擦除可編程邏輯器件 |
| 文件頁數： | 6/14頁 |
| 文件大?。?/td> | 104K |
| 代理商： | EDGE749 |
6
2000 Semtech Corp.
www.semtech.com
EDGE HIGH-PERFORMANCE PRODUCTS
Application Information
Edge749
Power Supplies
The Edge749 uses three power supplies
–
VDD, VCC
and VEE. VDD, typically +5V, is the digital supply for all
of the data inputs and outputs. VCC and VEE are the
analog power supplies for the DUT drivers and
comparators. VCC can range from +10V to +18V, and
must be greater than or equal to VDD. VEE is the negative
analog power and may vary from 0V to
–
3V.
The Edge749 has several power supply requirements to
protect the part in power supply fault situations, as well
as during power up and power down sequences. VCC
must remain greater than or equal to VDD at all times.
Both VCC and VDD must always be positive (above
ground), and VEE must always be negative (at or below
ground).
The three-Schottky diode configuration shown in Figure
5, used on a once-per-board basis, insures power supply
sequence and fault tolerance.
Figure 5.
Power Supply Protection Scheme
Power Supplies Decoupling
VDD, which provides the digital power, should be
decoupled to GND with a .1
μ
F chip capacitor in parallel
with a .001
μ
F chip capacitor. The bypass capacitors
should be as close to the device as possible. Power and
ground planes are recommended to provide a low
inductance return path.
VCC and VEE, which power the DUT drivers and receivers,
should also be decoupled to GND with a .1
μ
F chip
capacitor in parallel with a .001
μ
F chip capacitor. A
VCC and VEE plane, or at least a solid power bus, is
recommended for optimal performance.
V
HIGH
and V
LOW
Decoupling
As the V
HIGH
and V
LOW
inputs are unbuffered and must
supply the driver output current, decoupling capacitors
for these inputs are recommended in proportion to the
amount of output current the application requires.
Expanding the Common Mode Range
Although the Edge749 can drive and receive 18 V swings,
these 18 V signals can be adjusted over an 21 V range.
By using programmable regulators V1 and V2 for the
VCC and VEE supplies (feasible because these two
analog power supplies do not supply driver output
current), the Edge749 I/O range can be optimized for a
variety of applications (see Figure 6).
Figure 6.
There are three rules which govern the supplies V1 and
V2:
1) +10V < V1 < +18V
2)
–
3V < V2 < 0V
3) (V1
–
V2) < +18V.
VCC
VDD
VEE
1N5820 or
Equivalent
V1
Edge 749
V2
VCC
VDD
相關PDF資料 |
PDF描述 |
|---|---|
| EDGE749 | Low Power 5V RS232 Dual Driver/Receiver with 0.1?μF Capacitors; Package: SO; No of Pins: 16; Temperature Range: -40?°C to 85?°C |
| Edge818 | Octal 18V Pin Electronics Driver/window Comparator |
| EDI7F234IMC120BNC | 1Megx32 Flash Module |
| EDI7F2341MC80BNC | 1Megx32 Flash Module |
| EDI7F234IMC100BNC | 1Megx32 Flash Module |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EDGE749_02 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Octal Pin Electronics Driver/Receiver |
| EDGE7725 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:900 MHz Dual Pin Electronics Driver, Window Comparator, and Load |
| EDGE818 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Octal 18V Pin Electronics Driver/window Comparator |
| EDGE819 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Octal, 18V Pin Electronics Driver |
| EDGE-DET-E3-U1 | 功能描述:IP CORE 2D EDGE DETECTOR ECP3 RoHS:否 類別:編程器，開發系統 >> 軟件 系列:* 標準包裝:1 系列:ISE® 設計套件 類型:訂閱 適用于相關產品:Xilinx FPGAs 其它名稱:Q4986209T1081384 |
發布緊急采購，3分鐘左右您將得到回復。