參數資料
型號: EA-EDU-009
廠商: Embedded Artists
文件頁數: 9/37頁
文件大小: 0K
描述: BOARD EDUCATION LPC2103
標準包裝: 1
類型: MCU
適用于相關產品: LPC2103
所含物品:
LPC2101_02_03_4
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 04 — 2 June 2009
17 of 37
NXP Semiconductors
LPC2101/02/03
Single-chip 16-bit/32-bit microcontrollers
Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate watchdog reset.
Programmable 32-bit timer with internal pre-scaler.
Selectable time period from (TPCLK × 256 × 4) to (TPCLK × 232 × 4) in multiples of
TPCLK × 4.
6.16 Real-time clock
The Real-Time Clock (RTC) is designed to provide a set of counters to measure time
when normal or idle operating mode is selected. The RTC has been designed to use little
power, making it suitable for battery powered systems where the CPU is not running
continuously (Idle mode).
6.16.1 Features
Measures the passage of time to maintain a calendar and clock.
Ultra-low power design to support battery powered systems.
Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and Day
of Year.
Can use either the RTC dedicated 32 kHz oscillator input or clock derived from the
external crystal/oscillator input at XTAL1. The programmable reference clock divider
allows ne adjustment of the RTC.
Dedicated power supply pin can be connected to a battery or the main 3.3 V.
6.17 System control
6.17.1 Crystal oscillator
The on-chip integrated oscillator operates with external crystal in range of 1 MHz to
25 MHz. The oscillator output frequency is called fosc and the ARM processor clock
frequency is referred to as CCLK for purposes of rate equations, etc. fosc and CCLK are
the same value unless the PLL is running and connected. Refer to Section 6.17.2 “PLL”
and Section 10.1 “XTAL1 input” for additional information.
6.17.2 PLL
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up into the range of 10 MHz to 70 MHz with a Current Controlled
Oscillator (CCO). The multiplier can be an integer value from 1 to 32 (in practice, the
multiplier value cannot be higher than 6 on this family of microcontrollers due to the upper
frequency limit of the CPU). The CCO operates in the range of 156 MHz to 320 MHz, so
there is an additional divider in the loop to keep the CCO within its frequency range while
the PLL is providing the desired output frequency. The output divider may be set to divide
by 2, 4, 8, or 16 to produce the output clock. Since the minimum output divider value is 2,
it is insured that the PLL output has a 50 % duty cycle. The PLL is turned off and
bypassed following a chip reset and may be enabled by software. The program must
congure and activate the PLL, wait for the PLL to lock, and then connect to the PLL as a
clock source. The PLL settling time is 100
s.
相關PDF資料
PDF描述
0210490228 CABLE JUMPER 1.25MM .229M 16POS
0210490227 CABLE JUMPER 1.25MM .229M 16POS
IL13-US1-SVT-3100-183 LOCKING LINE CORD 3 COND US 6'
0210391015 CABLE JUMPER 1MM .102M 31POS
STD21W-W WIRE & CABLE MARKERS
相關代理商/技術參數
參數描述
EA-EDU-010 功能描述:開發板和工具包 - ARM LPC2138 EDUCATION BRD RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
EA-EDU-011 功能描述:開發板和工具包 - ARM EXPERIMENT EXPANSION BRD RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
EA-EL 3160-60 制造商:EA ELEKTRO-AUTOMATIK 功能描述:ELECTRONIC LOAD, 160V / 60A, EURO+UK
EA-EL 3160-60 制造商:EA Electro-Automatik GmbH 功能描述:ELECTRONIC LOAD 160V / 60A
EA-EL 3400-25 制造商:EA Electro-Automatik GmbH 功能描述:ELECTRONIC LOAD, 400V / 25A, EURO+UK