- 您現在的位置：買賣IC網 > PDF目錄97869 > DS75U-C12+T&R (MAXIM INTEGRATED PRODUCTS INC) DIGITAL TEMP SENSOR-SERIAL, 12BIT(s), 2Cel, SQUARE, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | DS75U-C12+T&R |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | Switch/Digital Output Temperature Sensor |
| 英文描述： | DIGITAL TEMP SENSOR-SERIAL, 12BIT(s), 2Cel, SQUARE, SURFACE MOUNT |
| 封裝： | LEAD FREE, MICRO MAX PACKAGE-8 |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 338K |
| 代理商： | DS75U-C12+T&R |
DS75
11 of 14
START Condition: Signal generated by the master to indicate the beginning of a data transfer on the
bus. The master generates a START condition by pulling SDA from high to low while SCL is high (see
Figure 6). A “repeated” START is sometimes used at the end of a data transfer (instead of a STOP) to
indicate that the master will perform another operation.
STOP Condition: Signal generated by the master to indicate the end of a data transfer on the bus. The
master generates a STOP condition by transitioning SDA from low to high while SCL is high (see Figure
6). After the STOP is issued, the master releases the bus to its idle state.
Acknowledge (ACK): When a device (either master or slave) is acting as a receiver, it must generate an
acknowledge (ACK) on the SDA line after receiving every byte of data. The receiving device performs an
ACK by pulling the SDA line low for an entire SCL period (see Figure 6). During the ACK clock cycle,
the transmitting device must release SDA. A variation on the ACK signal is the “not acknowledge”
(NACK). When the master device is acting as a receiver, it uses a NACK instead of an ACK after the last
data byte to indicate that it is finished receiving data. The master indicates a NACK by leaving the SDA
line high during the ACK clock cycle.
Slave Address: Every slave device on the bus has a unique 7-bit address that allows the master to access
that device. The DS75’s 7-bit bus address is 1 0 0 1 A2 A1 A0, where A2, A1 and A0 are user-selectable via
the corresponding input pins. The three address pins allow up to eight DS75s to be multi-dropped on the
same bus.
Address Byte: The control byte is transmitted by the master and consists of the 7-bit slave address plus a
read/write (R/W
) bit (see Figure 7). If the master is going to read data from the slave device then R/W
=
1, and if the master is going to write data to the slave device then R/W
= 0.
Pointer Byte: The pointer byte is used by the master to tell the DS75 which register is going to be
accessed during communication. The six LSbs of the pointer byte (see Figure 8) are always 0 and the two
LSbs correspond to the desired register as shown in Table 7.
Figure 6. START, STOP, AND ACK SIGNALS
Figure 7. ADDRESS BYTE
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
1
0
1
A2
A1
A0
R/W
Figure 8. POINTER BYTE
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
SCL
SDA
START
Condition
STOP
Condition
…
ACK (or NACK)
From Receiver
相關PDF資料 |
PDF描述 |
|---|---|
| DS75U | DIGITAL TEMP SENSOR-SERIAL, 12BIT(s), 2Cel, SQUARE, SURFACE MOUNT |
| DS75S | DIGITAL TEMP SENSOR-SERIAL, 12BIT(s), 2Cel, RECTANGULAR, SURFACE MOUNT |
| DS80C310-QCG | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44 |
| DS80C310-MCG | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PDIP40 |
| DS80C310-ECG | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS-7604HI-S | 制造商:Hikvision USA 功能描述:4-Chnl Hybrid Network DVRVga 1Tb Max 720P Chnl 制造商:HIKVISION 功能描述:4-CHNL HYBRID NETWORK DVR VGA 1TB MAX 720P CHNL |
| DS-7604NI-SE/P | 制造商:Hikvision USA 功能描述:4-Channel Embedded Plug and Play DVR with Built-In 4-Channel PoE Switch 制造商:HIKVISION 功能描述:NVR 4-CHANNEL H264 NO HDD HDMI AND INTEGRATED 4-PORT POE |
| DS-7608NI-SE/8P | 制造商:Hikvision USA 功能描述:8-Channel Embedded Plug and Play DVR with Built-In 8-Channel PoE Switch 制造商:HIKVISION 功能描述:NVR 8-CHANNEL H264 NO HDD HDMI AND INTEGRATED 8-PORT POE |
| DS760SL-3 | 功能描述:線性和開關式電源 748W 12V 63.3A FRONT END SLIMLINE RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| DS760SL-3-001 | 制造商:Emerson Network Power - Embedded Power 功能描述:12V OUTPUT, 5V STBY, 760W 1U X 1U X 12.67", REVERSE AIR - Bulk |
發布緊急采購，3分鐘左右您將得到回復。