- 您現在的位置：買賣IC網 > Datasheet目錄40 > DS75LVU+T&R (Maxim Integrated)IC SENSOR TEMP DIGITAL 8MSOP Datasheet資料下載
參數資料
| 型號： | DS75LVU+T&R |
| 廠商： | Maxim Integrated |
| 文件頁數： | 10/13頁 |
| 文件大小： | 275K |
| 描述： | IC SENSOR TEMP DIGITAL 8MSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 3,000 |
| 功能： | 溫度計，恒溫計 |
| 傳感器類型： | 內部 |
| 感應溫度： | -55°C ~ 125°C |
| 精確度： | ±3°C（最小值） |
| 拓?fù)洌?/td> | ADC（三角積分型），比較器，寄存器庫 |
| 輸出類型： | I²C?/SMBus? |
| 輸出警報： | 無 |
| 輸出風扇： | 無 |
| 電源電壓： | 1.7 V ~ 3.7 V |
| 工作溫度： | -55°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁
DS75LV: Digital Thermometer and Thermostat
Address Byte: The control byte is transmitted by the master and consists of the 7-bit slave address plus a
read/write (R/W) bit (see Figure 7). If the master is going to read data from the slave device then R/W = 1, and if
the master is going to write data to the slave device then R/W = 0.
Pointer Byte: The pointer byte is used by the master o tell the DS75LV which register is going to be accessed
during communication. The six MSbs of the pointer byte (see Figure 8) are always 0 and the two LSbs correspond
to the desired register as shown in Table 6.
Figure 6. Start, Stop, and ACK Signals
Figure 7. Address Byte
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
1
0
0
1
A
2
A
1
A
0
R/W
Figure 8. Pointer Byte
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
0
0
0
0
0
0
P1
P0
SCL
SDA
START
Condition
STOP
Condition
ACK (or NACK)
From Receiver
GENERAL 2-WIRE INFORMATION
All data is transmitted MSb first over the 2-wire bus.
One bit of data is transmitted on the 2-wire bus each SCL period.
A pullup resistor is required on the SDA line and, when the bus is idle, both SDA and SCL must remain in a logic-
high state.
All bus communication must be initiated with a START condition and terminated with a STOP condition. During a
START or STOP is the only time SDA is allowed to change states while SCL is high. At all other times, changes
on the SDA line can only occur when SCL is low: SDA must remain stable when SCL is high.
After every 8-bit (1-byte) transfer, the receiving device must answer with an ACK (or NACK), which takes one
SCL period. Therefore, nine clocks are required for every one-byte data transfer.
Writing to the DS75LV To write to the DS75LV, the master must generate a START followed by an address
byte containing the DS75LV bus address. The value of the R/W bit must be a 0, which indicates that a write is
about to take place. The DS75LV will respond with an ACK after receiving the address byte. The master then
sends a pointer byte which tells the DS75LV which register is being written to. The DS75LV will again respond with
an ACK after receiving the pointer byte. Following this ACK the master device must immediately begin transmitting
data to the DS75LV. When writing to the configuration register, the master must send one byte of data (see Figure
9b), and when writing to the T
OS
or T
HYST
registers the master must send two bytes of data (see Figure 9c). After
receiving each data byte, the DS75LV will respond with an ACK, and the transaction is finished with a STOP from
the master.
10 of 13
相關PDF資料 |
PDF描述 |
|---|---|
| DS75LXS+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS75U+T&R | IC THERMOMETER/STAT DIG 8-MSOP |
| FAN4010IL6X_F113 | IC CURRENT SENSE 0.2% 6MLP |
| FAN5069EMTCX | IC REG DL BCK/LINEAR 16TSSOP |
| HIP1011BCB-T | IC CTRLR HOT PLUG PCI 16-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS75LX | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Digital Thermometer and Thermostat with Extended Addressing |
| DS75LXS | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Digital Thermometer and Thermostat with Extended Addressing |
| DS75LXS+ | 功能描述:板上安裝溫度傳感器 w/Extended Addressing RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS75LXS+T&R | 制造商:Maxim Integrated Products 功能描述:TEMP SENSOR DGTL 2-WIRE 8SOIC N - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC THERMOMETER/STAT DIG 8-SOIC 制造商:Maxim Integrated Products 功能描述:Board Mount Temperature Sensors w/Extended Addressing |
| DS75LXS+T&R | 功能描述:板上安裝溫度傳感器 w/Extended Addressing RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
發布緊急采購，3分鐘左右您將得到回復。