參數資料
型號: DS620U+
廠商: Maxim Integrated
文件頁數: 5/15頁
文件大?。?/td> 243K
描述: IC THERMOMETER/STAT DIG 8MSOP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 50
功能: 溫度計,恒溫計
傳感器類型: 內部
感應溫度: -55°C ~ 125°C
精確度: ±2°C(最小值)
拓?fù)洌?/td> ADC(三角積分型),寄存器庫
輸出類型: I²C?/SMBus?
輸出警報:
輸出風扇:
電源電壓: 1.7 V ~ 3.5 V
工作溫度: -55°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)裸露焊盤
供應商設備封裝: 8-uMax-EP
包裝: 管件
產品目錄頁面: 1435 (CN2011-ZH PDF)
DS620 Digital Thermometer and Thermostat
 
 
 
5 of 15
Figure 2. Timing Diagram
 
 
 
 
 
 
Table 1. Register Summary
Parameter
Information
T
H
 and T
L
 Registers
Size: 2-Bytes
Note that the 3 LSbs are always dont cares for writes
(i.e., they are not saved) and always read out as 0s. 
EEPROM
Factory State:
TH = 15篊 (0000 0111 1000 0000) [0780h]
TL = 10篊 (0000 0101 0000 0000) [0500h]
Configuration Register
Size: 2-Bytes
SRAM and EEPROM. See Figure 4 and Table 5 for
detailed information and power-up/factory state.
Temperature Register
Size: 2-Bytes
SRAM Power-Up State: -60篊
(1110 0010 0000 0000) [E200h]
 
TEMPERATURE MEASUREMENT
The DS620 measures temperature using a bandgap-based temperature sensor. A delta-sigma, analog-to-digital
converter (ADC) converts measured temperature to a 10-, 11-, 12-, or 13-bit (user-selectable) digital value that is
calibrated in 癈; for 癋 applications, a lookup table or conversion routine must be used. Throughout this data sheet,
the term conversion is used to refer to the entire temperature measurement and ADC sequence.
 
The DS620 can be configured to power up either automatically converting temperature or in a low-power standby
state. The preferred power-up mode can be set using the AUTOC bit in the configuration register as explained in
the Configuration Register section of this data sheet.
 
The DS620 can be programmed to perform continuous consecutive conversions (continuous conversion mode) or
to perform single conversions on command (one-shot mode). The conversion mode is programmed through the
1SHOT bit in the configuration register as explained in the Configuration Register section of this data sheet. In
continuous conversion mode, conversions are performed after a Start Convert command is issued (or upon power-
up if the AUTOC bit in the configuration register is set to 1) until a Stop Convert command is issued, at which time
the device goes into a low-power standby state. Continuous conversions can be restarted at any time using the
Start Convert command. In one-shot mode, the DS620 performs a single temperature conversion either at power-
up (if AUTOC = 1) or when a Start Convert command is issued (if AUTOC = 0). When the conversion is complete,
相關PDF資料
PDF描述
DS7505U+T&R IC DGTL THERMOMETER 2WIRE 8-USOP
DS75LVU+T&R IC SENSOR TEMP DIGITAL 8MSOP
DS75LXS+ IC THERMOMETER/STAT DIG 8-SOIC
DS75U+T&R IC THERMOMETER/STAT DIG 8-MSOP
FAN4010IL6X_F113 IC CURRENT SENSE 0.2% 6MLP
相關代理商/技術參數
參數描述
DS620U/T&R 制造商:Maxim Integrated Products 功能描述:LOW VOLT THERM USOP T&R - Tape and Reel
DS620U/T&R 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
DS620U/TR 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Low-Voltage, +-0.5°C Accuracy Digital Thermometer and Thermostat
DS620U+ 功能描述:板上安裝溫度傳感器 Low-Voltage .5+/-C RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
DS620U+T&R 制造商:Maxim Integrated Products 功能描述:TEMP SENSOR DGTL 2-WIRE 8USOP - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC THERMOMETER/STAT DIG 8MSOP