- 您現在的位置：買賣IC網 > PDF目錄97868 > DS2415P (MAXIM INTEGRATED PRODUCTS INC) 0 TIMER(S), REAL TIME CLOCK, PDSO6 PDF資料下載
參數資料
| 型號： | DS2415P |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | Timer or RTC |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDSO6 |
| 封裝： | 0.150 INCH, TSOC-6 |
| 文件頁數： | 13/15頁 |
| 文件大?。?/td> | 341K |
| 代理商： | DS2415P |
DS2415
7 of 14
HARDWARE CONFIGURATION Figure 6
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the
DS2415 behaves as a slave. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specified time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire input of the DS2415 is open drain with an internal circuit equivalent
to that shown in Figure 6. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The 1-
Wire bus has a maximum data rate of 16.3kbits per second and requires a pullup resistor of approximately
5k
W.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
must be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 120
ms, one or more of the devices on the bus may be reset. Since the DS2415 gets all its
energy for operation through its VBAT pin it will not perform a power-on reset if the 1-Wire bus is low for
an extended time period.
Transaction Sequence
The protocol for accessing the DS2415 via the 1-Wire port is as follows:
§ Initialization
§ ROM Function Command
§ Clock Function Command
相關PDF資料 |
PDF描述 |
|---|---|
| DS2415X | 0 TIMER(S), REAL TIME CLOCK, X6 |
| DS2417X | 0 TIMER(S), REAL TIME CLOCK, PBGA6 |
| DS2417P | 0 TIMER(S), REAL TIME CLOCK, PDSO6 |
| DS2422X | SPECIALTY MEMORY CIRCUIT, UUC |
| DS2423P/T&R | SPECIALTY MEMORY CIRCUIT, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2415P/T&R | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS2415P/T&R-W | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS2415P+ | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS2415P+T&R | 制造商:Maxim Integrated Products 功能描述:IC TIME CHIP 1-WIRE 6-TSOC |
| DS2415P+T&R | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。