- 您現在的位置：買賣IC網 > PDF目錄359518 > DS1922T-F5 Temperature Logger iButton With 8kB Datalog Memory PDF資料下載
參數資料
| 型號： | DS1922T-F5 |
| 英文描述： | Temperature Logger iButton With 8kB Datalog Memory |
| 中文描述： | 溫度記錄儀iButton的記憶與8kB的數據記錄 |
| 文件頁數： | 23/48頁 |
| 文件大?。?/td> | 428K |
| 代理商： | DS1922T-F5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
DS1922L/DS1922T
23 of 48
The Full Access Password needs to be transmitted exactly in the sequence FP0, FP1… FP62, FP63. It will affect
the functions “Read Memory with CRC”, “Copy Scratchpad”, “Clear Memory”, “Start Mission”, and “Stop Mission”.
The DS1922L/T executes the command only if the password transmitted by the master was correct or if password
checking is not enabled
Due to the special behavior of the write access logic, the Password Control Register and both passwords must be
written at the same time. When setting up new passwords, always verify (read back) the scratchpad before sending
the copy scratchpad command. After a new password is successfully copied from the scratchpad to its memory
location, erase the scratchpad by filling it with new data (write scratchpad command). Otherwise a copy of the
passwords will remain in the scratchpad for public read access.
DATALOG MEMORY USAGE
Once setup for a mission, the DS1922L/T logs the temperature measurements at equidistant time points entry after
entry in its datalog memory. The datalog memory is able to store 8192 entries in 8-bit format or 4096 entries in 16-
bit format (Figure 7). In 16-bit format, the higher 8 bits of an entry are stored at the lower address. Knowing the
starting time point (Mission Time Stamp) and the interval between temperature measurements one can reconstruct
the time and date of each measurement.
There are two alternatives to the way the DS1922L/T will behave after the datalog memory is filled with data. The
user can program the device to either stop any further recording (disable “rollover”) or overwrite the previously
recorded data (enable “rollover”), one entry at a time, starting again at the beginning of the respective memory
section. The contents of the Mission Samples Counter in conjunction with the sample rate and the Mission Time
Stamp will then allow reconstructing the time points of all values stored in the datalog memory. This gives the exact
history over time for the most recent measurements taken. Earlier measurements cannot be reconstructed.
Figure 7. Temperature Logging
ETL = 1
TLFS = 0
8192
8-Bit Entries
Temperature
4096
16-Bit Entries
Temperature
1000h
2FFFh
1000h
2FFFh
ETL = 1
TLFS = 1
With 16-bit format,
the most-significant
byte is stored at the
lower address.
相關PDF資料 |
PDF描述 |
|---|---|
| DS3905U-020 | Triple 128-Position Nonvolatile Digital Variable Resistor/Switch |
| DR048 | DIGITAL FREQUENCY DISCRIMINATORS |
| DR050 | DIGITAL FREQUENCY DISCRIMINATORS |
| DR051 | DIGITAL FREQUENCY DISCRIMINATORS |
| DR053 | DIGITAL FREQUENCY DISCRIMINATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1922T-F5# | 功能描述:iButton Temp Logger Ibutton w/8Kb Datalog Mem RoHS:否 存儲類型:SRAM 存儲容量:512 B 組織: 工作電源電壓:3 V to 5.25 V 接口類型:1-Wire 最大工作溫度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封裝 / 箱體:F5 MicroCan 制造商:Maxim Integrated |
| DS1922T-F50 | 制造商:Maxim Integrated Products 功能描述:THERMOCHRON,IBTN,F5,HI-TEMP,8K - Rail/Tube |
| DS1923 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Hygrochron Temperature/Humidity Logger iButton with 8kB Data Log Memory |
| DS1923_1 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Hygrochron Temperature/Humidity Logger iButton with 8kB Data Log Memory |
| DS1923_11 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Hygrochron Temperature/Humidity Logger |
發布緊急采購，3分鐘左右您將得到回復。