- 您現在的位置：買賣IC網 > PDF目錄358701 > DS1922L Temperature Logger iButton with 8kB Datalog Memory PDF資料下載
參數資料
| 型號： | DS1922L |
| 英文描述： | Temperature Logger iButton with 8kB Datalog Memory |
| 文件頁數： | 34/48頁 |
| 文件大小： | 428K |
| 代理商： | DS1922L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
DS1922L/DS1922T
34 of 48
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to drive it at
the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open drain or tri-state
outputs. The 1-Wire port of the DS1922L/T is open-drain with an internal circuit equivalent to that shown in Figure
10.
A multidrop bus consists of a 1-Wire bus with multiple slaves attached. At standard speed the 1-Wire bus has a
maximum data rate of 16.3kbps. The speed can be boosted to 142kbps by activating the Overdrive mode. The
DS1922L/T is not guaranteed to be fully compliant to the iButton standard. Its maximum data rate in standard
speed mode is 15.4kbps and 125kbps in Overdrive. The value of the pullup resistor primarily depends on the
network size and load conditions. The DS1922L/T requires a pullup resistor of maximum 2.2k at any speed.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus MUST be
left in the idle state if the transaction is to resume. If this does not occur and the bus is left low for more than 16μs
(Overdrive speed) or more than 120μs (standard speed), one or more devices on the bus may be reset. Note that
the DS1922L/T does not quite meet the full 16μs maximum low time of the normal 1-Wire bus Overdrive timing.
With the DS1922L/T the bus must be left low for no longer than 12μs at Overdrive to ensure that no DS1922L/T on
the 1-Wire bus performs a reset. The DS1922L/T communicates properly when used in conjunction with a
DS2480B or DS2490 1-Wire driver and adapters that are based on these driver chips.
Figure 10. Hardware Configuration
Open-Drain
Port Pin
RX = RECEIVE
TX = TRANSMIT
100
MOSFET
V
PUP
RX
TX
TX
RX
DATA
5μA
Typ.
BUS MASTER
DS1922L/T 1-Wire PORT
R
PUP
TRANSACTION SEQUENCE
The protocol for accessing the DS1922L/T through the 1-Wire port is as follows:
Initialization
ROM Function Command
Memory/Control Function Command
Transaction/Data
INITIALIZATION
All transactions on the 1-Wire bus begin with an initialization sequence. The initialization sequence consists of a
reset pulse transmitted by the bus master followed by presence pulse(s) transmitted by the slave(s). The presence
pulse lets the bus master know that the DS1922L/T is on the bus and is ready to operate. For more details, see the
1-Wire Signaling
section.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1922T | Temperature Logger iButton with 8kB Datalog Memory |
| DS1922L-F5 | Temperature Logger iButton With 8kB Datalog Memory |
| DS1992 | 1kb/4kb Memory iButton |
| DS1993 | 1kb/4kb Memory iButton |
| DS1992L-F5 | 1kbit/4kbit Memory iButtonTM DS1994 4-kbit Plus Time Memory iButtonTM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1922L_11 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Temperature Logger iButton with 8KB Data-Log Memory |
| DS1922L-F5 | 功能描述:iButton RoHS:否 存儲類型:SRAM 存儲容量:512 B 組織: 工作電源電壓:3 V to 5.25 V 接口類型:1-Wire 最大工作溫度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封裝 / 箱體:F5 MicroCan 制造商:Maxim Integrated |
| DS1922L-F5# | 功能描述:iButton Temp Logger Ibutton w/8Kb Datalog Mem RoHS:否 存儲類型:SRAM 存儲容量:512 B 組織: 工作電源電壓:3 V to 5.25 V 接口類型:1-Wire 最大工作溫度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封裝 / 箱體:F5 MicroCan 制造商:Maxim Integrated |
| DS1922L-F5#A20 | 功能描述:iButton RoHS:否 存儲類型:SRAM 存儲容量:512 B 組織: 工作電源電壓:3 V to 5.25 V 接口類型:1-Wire 最大工作溫度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封裝 / 箱體:F5 MicroCan 制造商:Maxim Integrated |
發布緊急采購，3分鐘左右您將得到回復。