參數資料
型號： DS1878T+T&R
廠商： Maxim Integrated Products
文件頁數： 16/101頁
文件大小： 0K
描述： IC CTLR SFP W/DGTL LDD RX 28TQFN
標準包裝： 2,500
類型： SFP+ 控制器
輸入類型： 模擬，數字
輸出類型： 數字
接口： I²C，LDD，串行
電流 - 電源： 2.5mA
安裝類型： 表面貼裝
封裝/外殼： 28-WFQFN 裸露焊盤
供應商設備封裝： 28-TQFN-EP（5x5）
包裝： 帶卷 (TR)
DS1878
SFP+ Controller with Digital LDD Interface
______________________________________________________________________________________
21
LUT LOADED TO [7:0]
DAC[1/2]TI
8
7
6
5
4
3
2
1
0
DAC[1/2]TI
DAC[1/2]TC = 0
TEMPERATURE (
°C)
-40
+102
TEMPERATURE (
°C)
-40
+102
DAC[1/2]TC = 1
LUT LOADED TO [8:1]
(DAC BIT 0 = 0)
LUT LOADED TO [8:1]
(DAC BIT 0 = 0)
DELTA-SIGMA
DACA
OR
DACB
8
7
6
5
4
3
2
1
0
DELTA-SIGMA
DACA
OR
DACB
Figure 13. DAC1/DAC2 LUT Assignments
In LUT mode, DAC1 and DAC2 are each controlled by
a separate 8-bit, 4°C-resolution, temperature-
addressed LUT. The delta-sigma outputs use a 10-bit
structure. The 8-bit LUTs are either loaded directly into
the MSBs (8:1) or the LSBs (7:0). This is determined by
DAC1TI (Table 02h, Register C3h), DAC2TI (Table 02h,
Register C4h), DAC1TC (Table 02h, Register C6h, bit
6), and DAC2TC (Table 02h, Register C6h, bit 5). See
Figure 13 for more details. The DAC1 LUT (Table 07h)
and DAC2 LUT (Table 08h) registers are nonvolatile
and password-2 protected.
The reference input, REFIN, is the supply voltage for
the output buffer of DAC1 and DAC2. The voltage con-
nected to REFIN must be able to support the edge rate
requirements of the delta-sigma outputs. In a typical
application, a 0.1F capacitor should be connected
between REFIN and ground.
Digital I/O Pins
Five digital input and four digital output pins are provid-
ed for monitoring and control.
LOS, LOSOUT
By default (LOSC = 1, Table 02h, Register 89h), the
LOS pin is used to convert a standard comparator out-
put for loss of signal (LOS) to an open-collector output.
This means the mux shown in the
Block Diagram by
default selects the LOS pin as the source for the
LOSOUT output transistor. The output of the mux can
be read in the STATUS byte (Lower Memory,
Register 6Eh) as the RXL bit. The RXL signal can be
inverted (INV LOS = 1) before driving the open-drain
output transistor using the XOR gate provided. Setting
LOSC = 0 configures the mux to be controlled by LOS
LO, which is driven by the output of the LOS quick trip
(Table 02h, Registers BEh and BFh). The mux setting
(stored in EEPROM) does not take effect until VCC >
POA, allowing the EEPROM to recall.
相關PDF資料
PDF描述
DS1881Z-050+T&R IC DGTL POT NV 2CH 45K 16-SOIC
DS1882Z-050+T&R IC POT DIGIT DL LOG 50K 16SOIC
DS1884AT+T IC SFP PON ONU CTRLR 24TQFN
DS2105Z+ IC SCSI TERMINATOR 16-SOIC
DS2106S/T&R IC TERMINATOR SCSI 28-SOIC
相關代理商/技術參數
參數描述
DS-187PU 制造商:Shinagawa Shoko 功能描述:
DS-187U 制造商:Shinagawa Shoko 功能描述:
DS1880E-050 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
DS1880E-050/T&R 制造商:Maxim Integrated Products 功能描述:DUAL LOG POT + EQUALIZER T&R - Tape and Reel
DS1880E-050/T&R 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*