- 您現在的位置：買賣IC網 > PDF目錄299012 > DS1867-100 Dual Digital Potentiometer with EEPROM PDF資料下載
參數資料
| 型號： | DS1867-100 |
| 元件分類： | 數字電位計 |
| 英文描述： | Dual Digital Potentiometer with EEPROM |
| 中文描述： | 雙數字電位器帶有EEPROM |
| 文件頁數： | 4/14頁 |
| 文件大?。?/td> | 308K |
| 代理商： | DS1867-100 |
DS1867
12 of 14
102199
NOTES:
1. All voltages are referenced to ground.
2. Resistor inputs cannot exceed the substrate bias voltage, VB, in the negative direction.
3. Capacitance values apply at 25
°C.
4. Absolute linearity is used to determine wiper voltage versus expected voltage as determined by wiper
position. Test limits for absolute linearity are
±1.6 LSB.
5. Relative linearity is used to determine the change in voltage between successive tap positions. Test
limits for relative linearity are
±0.5 LSB.
6. Typical values are for tA =25
°C and nominal supply voltage.
7. -3 dB cutoff frequency characteristics for the DS1867 depend on potentiometer total resistance:
DS1867-010; 1 MHz, DS1867-050; 200 kHz, DS1867-100; 100 kHz.
8. COUT is active regardless of the state of RST .
9. Power-down time is specified at a minimum of 4 ms. It is the time required for the DS1867 to
guarantee wiper position storage as VCC moves from 4.5V to 3.0V.
10. This is the time from power trip-point min (3.9V) to 3.0V to guarantee wiper storage.
11. tREC is the time required before the DS1867 stored wiper position becomes valid on power-up.
12. Power trip points reference required voltage necessary for DS1867 to restore the stored wiper position
setting.
13. See Figure 11.
14. During power-up the wiper position will be set at 80H.
15. See Figure 2.
16. A device write is specified as being a controlled power-down providing enough time to complete an
EEPROM write. It is also defined as a complete bit change from one value to another, i.e., 0 to 1.
Power-downs which do not change the wiper value can be expected have 200,000-write durability.
17. Valid at 25
°C only.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1867-50 | Dual Digital Potentiometer with EEPROM |
| DS1868-10 | Dual Digital Potentiometer Chip |
| DS1868-100 | Dual Digital Potentiometer Chip |
| DS1869-10 | 3V Dallastat Electronic Digital Rheostat |
| DS1869-100 | 3V Dallastat Electronic Digital Rheostat |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1867-100+ | 功能描述:數字電位計 IC Dual w/EEPROM RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1867-50 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1867-50+ | 功能描述:數字電位計 IC Dual w/EEPROM RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1867E-010 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Potentiometer |
| DS1867E-010/T&R | 制造商:Maxim Integrated Products 功能描述:IC POT W/EEPROM DUAL 10K 20TSSOP |
發布緊急采購，3分鐘左右您將得到回復。