- 您現在的位置：買賣IC網 > PDF目錄9184 > DS1866Z (Maxim Integrated Products)IC POT TRIM LOG 2.7-5.5V 8-SOIC PDF資料下載
參數資料
| 型號： | DS1866Z |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/5頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC POT TRIM LOG 2.7-5.5V 8-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 100 |
| 接片： | 8 |
| 電阻（歐姆）： | 10k |
| 電路數： | 1 |
| 溫度系數： | 標準值 750 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | 3 輸入并口 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
DS1866
2 of 5
102199
OPERATION
The DS1866 is a single volatile potentiometer. The device has a total of eight positions providing a
resolution of 5 dB per step and giving a total attenuation range of 0 dB to -35 dB. These tap points are
accessible to the W-terminal whose position is controlled via a 3-terminal parallel port consisting of input
signals P0, P1, and P2. A block diagram of the DS1866 is shown in Figure 1.
Wiper position setting of the DS1866 is determined by the states of the P0, P1, and P2 input terminals.
Table 1 below outlines position setting versus value of the parallel port inputs. A Position-0 setting places
the wiper position at the L-terminal of the potentiometer and provides 35 dB of attenuation. As wiper
position increases, attenuation decreases with Position-7 giving 0 dB of attenuation.
On power-up, the wiper position of the DS1866 will be set to the P0, P1, and P2 values.
P2 P1 P0
(binary)
Wiper
Position
Attenuation
(dB)
000
0
35 dB
001
1
30 dB
010
2
25 dB
011
3
20 dB
100
4
15 dB
101
5
10 dB
110
6
5 dB
111
7
0 dB
PIN DESCRIPTIONS
VCC - Power Supply Terminal. The DS1866 will support supply voltages ranging from +2.7 to +5.5
volts.
GND - Ground Terminal.
H - High-end Resistor. This is the high-end terminal of the potentiometer. It is not required that this
terminal be connected to a potential greater than the L-terminal. Maximum voltage on the H-terminal can
not exceed the power supply voltage, VCC, or go below ground.
L - Low-end Resistor. This is the low-end terminal of the potentiometer. It is not required that this
terminal be connected to a potential less than the H-terminal. Maximum voltage on the L-terminal can not
exceed the power-supply voltage, VCC, or go below ground.
W - Wiper of the Potentiometer. This pin is the wiper terminal of the potentiometer. Its position on the
resistor array is controlled by the 3-terminal parallel port. Maximum voltage on the W-terminal can not
exceed the power supply voltage, VCC, or go below ground.
P0 - Bit 0. P0 is the bit 0 data input to the parallel port.
P1 - Bit 1. P1 is the bit 1 data input to the parallel port.
P2 - Bit 2. P2 is the bit 2 data input to the parallel port.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2W2-MY-F2 | CONVERTER MOD DC/DC 15V 50W |
| VE-2W2-MY-F1 | CONVERTER MOD DC/DC 15V 50W |
| VI-B6W-MW-B1 | CONVERTER MOD DC/DC 5.5V 100W |
| VE-2W1-MY-F4 | CONVERTER MOD DC/DC 12V 50W |
| VE-2W1-MY-F3 | CONVERTER MOD DC/DC 12V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1866Z/T&R | 制造商:Maxim Integrated Products 功能描述:DIG LOG TRIM POT 10KOHM 8L 150ML TR - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT TRIM LOG 2.7-5.5V 8-SOIC |
| DS1866Z/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1866Z+ | 功能描述:數字電位計 IC Log Trimmer RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1866Z+T&R | 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 8POS 10KOHM SGL 8SOIC N - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT TRIM LOG 2.7-5.5V 8-SOIC 制造商:Maxim Integrated Products 功能描述:Digital Potentiometer ICs Log Trimmer |
| DS1866Z+T&R | 功能描述:數字電位計 IC Log Trimmer RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。