- 您現在的位置：買賣IC網 > PDF目錄299012 > DS1855X-020 Dual Nonvolatile Digital Potentiometer and Secure Memory PDF資料下載
參數資料
| 型號： | DS1855X-020 |
| 元件分類： | 數字電位計 |
| 英文描述： | Dual Nonvolatile Digital Potentiometer and Secure Memory |
| 中文描述： | 雙非易失數字電位器及安全存儲器 |
| 文件頁數： | 12/20頁 |
| 文件大?。?/td> | 252K |
| 代理商： | DS1855X-020 |
DS1855
2 of 20
PIN DESCRIPTIONS
Name TSSOP BGA
Description
VCC
14
A3
Power Supply Terminal. The DS1855 will support supply
voltages ranging from +2.7V to +5.5V.
GND
7
D1
Ground Terminal.
SDA
1
B2
2-Wire serial data interface. The serial data pin is for serial data
transfer to and from the DS1855. The pin is open drain and may
be wire-ORed with other open drain or open collector interfaces.
SCL
2
A2
2-Wire Serial Clock Input. The serial clock input is used to
clock data into the DS1855 on rising edges and clock data out on
falling edges.
WP
6
C1
Write Protect Input. If set to logic 0, the data in memory and the
potentiometer wiper setting may be changed. If set to logic 1, both
the memory and the potentiometer wiper settings will be write
protected. The WP pin is pulled high internally.
A0
3
A1
Address Input. Pins A0, A1, and A2 are used to specify the
address of each DS1855 when used in a multi-dropped
configuration. Up to eight DS1855s may be addressed on a single
2-wire bus.
A1
4
B1
Address Input.
A2
5
C2
Address Input.
H0
13
A4
High terminal of Potentiometer 0. For both potentiometers, it is
not required that the high terminal be connected to a potential
greater than the low terminal. Voltage applied to the high terminal
of each potentiometer cannot exceed VCC or go below ground.
H1
11
B3
High terminal of Potentiometer 1.
L0
8
D3
Low terminal of Potentiometer 0. For both potentiometers, it is
not required that the low terminal be connected to a potential less
than the high terminal. Voltage applied to the low terminal of each
potentiometer cannot exceed VCC or go below ground.
L1
10
C4
Low terminal of Potentiometer 1.
W0
9
D4
Wiper terminal of Pot 0. The wiper position of Potentiometer 0
is determined by the byte at EEPROM memory location F9h.
Voltage applied to the wiper terminal of each potentiometer cannot
exceed the power supply voltage, VCC, or go below ground.
W1
12
B4
Wiper terminal of Pot 1. The wiper position of Potentiometer 1
is determined by the byte at EEPROM memory location F8h.
NC
C3
No Connect.
NC
D2
No Connect.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1867-10 | Dual Digital Potentiometer with EEPROM |
| DS1867-100 | Dual Digital Potentiometer with EEPROM |
| DS1867-50 | Dual Digital Potentiometer with EEPROM |
| DS1868-10 | Dual Digital Potentiometer Chip |
| DS1868-100 | Dual Digital Potentiometer Chip |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1855X-050 | 制造商:Maxim Integrated Products 功能描述:DUAL NV POT & MEMORY WITH LOCKOUT - Tape and Reel |
| DS1855X-050#T&R | 制造商:Maxim Integrated Products 功能描述:IC DUAL NV DGTL POT/MEM 14-FCP |
| DS1855X-050#T&R | 功能描述:數字電位計 IC Dual NV w/Memory RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1855X-050/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL NV POT & MEMORY WITH LOCKOUT - Tape and Reel |
| DS1855X-050/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。