- 您現在的位置：買賣IC網 > PDF目錄385272 > DS1834 (MAXIM INTEGRATED PRODUCTS INC) Dual EconoReset with Pushbutton(帶復位按鈕的雙路Econo復位電路) PDF資料下載
參數資料
| 型號： | DS1834 |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | Dual EconoReset with Pushbutton(帶復位按鈕的雙路Econo復位電路) |
| 中文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDIP8 |
| 封裝： | 0.300 INCH, DIP-8 |
| 文件頁數： | 3/7頁 |
| 文件大?。?/td> | 60K |
| 代理商： | DS1834 |
DS1834/A/D
062698 3/7
Tolerance Select
The DS1834 provides two TOL inputs for individual cus-
tomization of the DS1834 to specific application require-
ments. If the TOL for the 5 volt supply is tied to the 5 volt
input a 10% tolerance is selected for the 5 volt supply. If
the TOL for the 3.3 volt supply is tied to the 3.3 volt input
a 20% tolerance is selected for the 3.3 volt supply. If
TOL inputs are tied to ground the 5 volt input will be set
at a 5% tolerance and the 3.3 volt input would be set to a
10% tolerance.
Pushbutton Reset
The DS1834 provides a pushbutton switch for manual
reset control. When at least one of the DS1834 resets
are not in a reset cycle, a pushbutton reset can be gen-
erated by pulling the PBRST pin low for at least 2 ms.
When the pushbutton is held low, both resets are forced
active and will remain active for about 350 ms after the
pushbutton is released. The pushbutton input is pulled
high through an internal 40K
pull–up resistor and
debounced via internal circuitry. See Figure 3 for an
application example and Figure 4 for the timing dia-
gram.
PUSHBUTTON RESET
Figure 3
RST (5V)
TOL (5V)
GND
RST (3.3V)
TOL (3.3V)
PBRST
DS1834
5V
IN
3.3V
IN
TIMING DIAGRAM: PUSHBUTTON RESET
Figure 4
V
OH
V
OL
V
IH
V
IL
t
RST
t
PDLY
t
PB
PBRST
RST
RST (DS1834D ONLY)
相關PDF資料 |
PDF描述 |
|---|---|
| DS1834A | Dual EconoReset with Pushbutton(帶復位按鈕的雙路Econo復位電路) |
| DS1834D | Dual EconoReset with Pushbutton(帶復位按鈕的雙路Econo復位電路) |
| DS1836A | 5V MicroManager(5V微管理器) |
| DS1836B | 5V MicroManager(5V微管理器) |
| DS1836C | 3.3V MicroManager(3.3V微管理器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1834/A/D | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Dual EconoReset with Pushbutton |
| DS1834+ | 功能描述:監控電路 Dual EconoReset w/Pushbutton RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1834A | 功能描述:監控電路 Dual EconoReset w/Pushbutton RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1834A+ | 功能描述:監控電路 Dual EconoReset w/Pushbutton RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1834A+T&R | 制造商:Maxim Integrated Products 功能描述:PROCESSOR SUPERVISOR 4.63V/2.88V 50UA 8PDIP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。