- 您現在的位置：買賣IC網 > PDF目錄9328 > DS1693 (Maxim Integrated Products)IC RTC W/NV RAM 3V/5V 28-EDIP PDF資料下載
參數資料
| 型號： | DS1693 |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 13/36頁 |
| 文件大小： | 0K |
| 描述： | IC RTC W/NV RAM 3V/5V 28-EDIP |
| 標準包裝： | 12 |
| 類型： | 時鐘/日歷 |
| 特點： | NVSRAM |
| 存儲容量： | 114B |
| 時間格式： | HH:MM:SS（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | 并聯 |
| 電源電壓： | 2.7 V ~ 3.3 V，4.5 V ~ 5.5 V |
| 電壓 - 電源，電池： | 2.5 V ~ 3.7 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 28-DIP 模塊（0.600"，15.24mm） |
| 供應商設備封裝： | 28-EDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
DS1689/DS1693
20 of 36
applied, the on-chip logic always attempts to drive the
PWR pin active in response to the enabled
kickstart or wake-up condition. This is true even if
PWR was previously inactive as the result of power
being applied by some means other than wake-up or kickstart.
The system can be powered down under software control by setting the PAB bit to logic 1. This causes
the open-drain
PWR pin to be placed in a high-impedance state, as shown at the beginning of interval 4 in
the timing diagram. As VCC voltage decays, the IRQ output pin is placed in a high-impedance state when
VCC goes below VPF. If the system is to be again powered on in response to a wake-up or kickstart, then
both the WF and KF flags should be cleared and WIE and/or KSE should be enabled prior to setting the
PAB bit.
During interval 5, the system is fully powered down. Battery backup of the clock calendar and NV RAM
is in effect,
PWR and IRQ are tri-stated, and monitoring of wake-up and kickstart takes place.
RAM CLEAR
The DS1689/DS1693 provide a RAM clear function for the 114 bytes of user RAM. When enabled, this
function can be performed regardless of the condition of the VCC pin.
The RAM clear function is enabled or disabled via the RAM Clear Enable bit (RCE; bank 1, register
04BH). When this bit is set to logic 1, the 114 bytes of user RAM are cleared (all bits set to 1) when an
active-low transition is sensed on the
RCLR pin. This action has no effect on either the clock/calendar
settings or upon the contents of the external extended RAM. The RAM clear flag (RF, bank 1, register
04BH) is set when the RAM clear operation has been completed. If VCC is present at the time of the RAM
clear and RIE = 1, the
IRQ line is also driven low upon completion. The interrupt condition can be
cleared by writing a 0 to the RF bit. The
IRQ line then returns to its inactive high level, provided there are
no other pending interrupts. Once the
RCLR pin is activated, all read/write accesses are locked out for a
minimum recover time, specified as tREC in the Electrical Characteristics section.
When RCE is cleared to 0, the RAM clear function is disabled. The state of the
RCLR pin has no effect
on the contents of the user RAM, and transitions on the
RCLR pin have no effect on RF.
相關PDF資料 |
PDF描述 |
|---|---|
| MS3450W18-13PX | CONN RCPT 4POS WALL MNT W/PINS |
| MCP4262T-104E/MF | IC POT DGTL DUAL 100K RHEO 10DFN |
| MS3450W18-13PW | CONN RCPT 4POS WALL MNT W/PINS |
| MCP4262T-503E/MF | IC POT DGTL DUAL 50K RHEO 10DFN |
| DS1746WP-120 | IC RTC RAM Y2K 3.3V 120NS 34-PCM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1693+ | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1697N WAF | 制造商:Texas Instruments 功能描述: |
| DS1699-010 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
| DS1699-10 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
| DS1699-100 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
發布緊急采購，3分鐘左右您將得到回復。