- 您現在的位置：買賣IC網 > PDF目錄379179 > DS1615X Temperature Recorder PDF資料下載
參數資料
| 型號： | DS1615X |
| 英文描述： | Temperature Recorder |
| 中文描述： | 溫度記錄儀 |
| 文件頁數： | 20/24頁 |
| 文件大?。?/td> | 199K |
| 代理商： | DS1615X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁
DS1615
20 of 24
Note that the Specification test command is ignored if the ST button is pulled to ground when the
command is issued.
4. Read Temperature (55h)
Host Transmit:
D7
D6
D5
D4
D3
D2
D1
D0
0
1
0
1
0
1
0
1
DS1615 Response (Host Receives): When the device is not currently datalogging (i.e., MIP = 0), the
Temperature is immediately measured and value is written to the Current Temperature register.
This command instructs the DS1615 to immediately perform a temperature measurement and to store the
resulting value in the Current Temperature register. The temperature value obtained from this command
is not stored in the datalog or histogram memory. After this command has been executed, the user must
read the Temperature Ready (TR) bit in the Status register to determine if the temperature measurement
has been completed. If the TR bit is a logic 1, the measurement has been completed and the value in the
Current Temperature register is valid. If the TR bit is a logic 0, the measurement has not been completed.
This command functions only when MIP = 0 (i.e., the device is not currently datalogging). If MIP =1, the
DS1615 takes no action in response to the command.
5. Clear Memory (A5h)
Host Transmit:
D7
D6
D5
D4
D3
D2
D1
D0
1
0
1
0
0
1
0
1
DS1615 Response: The contents of the datalog, histogram, Temperature Alarm, Current Samples, Start
Time Stamp, Start Delay, and Sample Rate registers are cleared if the Clear Memory command has been
enabled by setting the CLR bit in the Control register to a one. After clearing the memory, the MEM
CLR bit in the Status register is set. The Clear Memory command functions only if the oscillator is
active. The DS1615 is inaccessible for 500
μ
s after the Clear Memory command has been issued.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1616 | Temperature and Three Input MUX’ed 8-bit Data Recorder |
| DS1616S | Temperature and Three Input MUX’ed 8-bit Data Recorder |
| DS1620R | Self?Heating Temperature Sensor |
| DS1621 | Digital Thermometer and Thermostat |
| DS1624 | Digital Thermometer and Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1616 | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS1616K-000 | 功能描述:KIT EVAL TEMP A/D DATA RECORDER RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| DS1616S | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Temperature and Three Input MUX’ed 8-bit Data Recorder |
| DS-1616ZJ | 制造商:Hikvision USA 功能描述:Pendant Wall Mount Bracket 3.8In X 7.65In X 12.2In 制造商:HIKVISION 功能描述:PENDANT WALL MOUNT BRACKET 3.8IN X 7.65IN X 12.2IN |
| DS16177D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Bus Transceiver |
發布緊急采購，3分鐘左右您將得到回復。