- 您現在的位置：買賣IC網 > PDF目錄9164 > DS1086LU-533+ (Maxim Integrated Products)IC ECONOSCILLATOR SS 8-USOP PDF資料下載
參數資料
| 型號： | DS1086LU-533+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 17/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ECONOSCILLATOR SS 8-USOP |
| 其它有關文件： | Automotive Product Guide |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 50 |
| 系列： | EconOscillator™ |
| 類型： | 擴展頻譜時鐘發生器 |
| PLL： | 無 |
| 輸入： | 時鐘 |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 無/無 |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 2.7 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 管件 |
| 產品目錄頁面： | 1435 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁
3.3V Spread-Spectrum EconOscillator
Maxim Integrated
9
DS1086L
Detailed Description
A block diagram of the DS1086L is shown in Figure 3.
The internal master oscillator generates a square wave
with a 33.3MHz to 66.6MHz frequency range. The fre-
quency of the master oscillator can be programmed
with the DAC register over a two-to-one range in 5kHz
steps. The master oscillator range is larger than the
range possible with the DAC step size, so the OFFSET
register is used to select a smaller range of frequencies
over which the DAC spans. The prescaler can then be
set to divide the master oscillator frequency by 2x
(where x equals 0 to 8) before routing the signal to the
output (OUT) pin.
A programmable triangle-wave generator injects an off-
set element into the master oscillator to dither its output
0.5%, 1%, 2%, 4%, or 8%. The dither magnitude is con-
trolled by the JS2, JS1, and JS0 bits in the PRESCALER
word and enabled with the SPRD pin. Futhermore, the
dither rate is controlled by the JS4 and JS3 bits in the
PRESCALER word and determines the frequency of the
dither. The maximum spectral attenuation occurs when
the prescaler is set to 1 and is reduced by 2.7dB for
every factor of 2 that is used in the prescaler. This
happens because the prescaler’s divider function tends
to average the dither in creating the lower frequency.
However, the most stringent spectral emission limits are
imposed on the higher frequencies where the prescaler
is set to a low divider ratio.
The external control input, OE, gates the clock output
buffer. The PDN pin disables the master oscillator and
turns off the clock output for power-sensitive applica-
tions*. On power-up, the clock output is disabled until
power is stable and the master oscillator has generated
512 clock cycles. Both controls feature a synchronous
enable that ensures there are no output glitches when
the output is enabled.
The control registers are programmed through a 2-wire
interface and are used to determine the output frequen-
cy and settings. Once programmed into EEPROM,
since the register settings are NV, the settings only
need to be reprogrammed if it is desired to reconfigure
the device.
SDA
VCC
SCL
2-WIRE
INTERFACE
VCC
DAC
OFFSET
EEPROM CONTROL
REGISTERS
PRESCALER
ADDR
RANGE
SPRD
PDN
OUT
OE
DAC
TRIANGLE WAVE
GENERATOR
VOLTAGE-CONTROLLED
OSCILLATOR
PRESCALER
BY 1, 2, 4...256
GND
MASTER
OSCILLATOR
OUTPUT
DITHER SIGNAL
DITHER
CONTROL
FREQUENCY
CONTROL VOLTAGE
DS1086L
Figure 3. Block Diagram
*
The power-down command must persist for at least two out-
put frequency cycles plus 10μs for deglitching purposes.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BNX-MW-B1 | CONVERTER MOD DC/DC 5.2V 100W |
| V110A12H300B3 | CONVERTER MOD DC/DC 12V 300W |
| DS1086LU+ | IC ECONOSILL 3.3V SS 8-USOP |
| VE-BNM-MV | CONVERTER MOD DC/DC 10V 150W |
| V110A12H300B | CONVERTER MOD DC/DC 12V 300W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1086LU-533+ | 功能描述:可編程振蕩器 3.3V Spread-Spectrum EconOscillator RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1086LU-533+T | 功能描述:可編程振蕩器 3.3V Spread-Spectrum EconOscillator RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1086LU-553+W | 制造商:Maxim Integrated Products 功能描述: |
| DS1086LU-66 | 功能描述:可編程振蕩器 RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1086LU-834 | 功能描述:可編程振蕩器 RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
發布緊急采購，3分鐘左右您將得到回復。