- 您現在的位置：買賣IC網 > PDF目錄385270 > DNS10S0A0S16PFD (Delta Electronics, Inc.) Delphi DNS, Non-Isolated Point of Load DC/DC Power Modules: 2.8-5.5Vin, 0.75-3.3V/6Aout PDF資料下載
參數資料
| 型號： | DNS10S0A0S16PFD |
| 廠商： | Delta Electronics, Inc. |
| 英文描述： | Delphi DNS, Non-Isolated Point of Load DC/DC Power Modules: 2.8-5.5Vin, 0.75-3.3V/6Aout |
| 中文描述： | 德爾福的DNS，非隔離負載點DC / DC電源模塊：2.8 5.5Vin，0.75-3.3V/6Aout |
| 文件頁數： | 13/17頁 |
| 文件大?。?/td> | 773K |
| 代理商： | DNS10S0A0S16PFD |
DS_DNS04SMD6A_10202006
13
Figure 46:
Output current vs. ambient temperature and air
velocity@Vin=5V, Vout=1.5V(Either Orientation)
THERMAL CONSIDERATIONS
Thermal management is an important part of the system
design. To ensure proper, reliable operation, sufficient
cooling of the power module is needed over the entire
temperature range of the module. Convection cooling is
usually the dominant mode of heat transfer.
Hence, the choice of equipment to characterize the
thermal performance of the power module is a wind
tunnel.
Thermal Testing Setup
Delta’s DC/DC power modules are characterized in
heated vertical wind tunnels that simulate the thermal
environments
encountered
equipment. This type of equipment commonly uses
vertically mounted circuit cards in cabinet racks in which
the power modules are mounted.
The
following
figure
shows
characterization setup. The power module is mounted
on a test PWB and is vertically positioned within the
wind tunnel. The height of this fan duct is constantly kept
at 25.4mm (1’’).
Thermal Derating
Heat can be removed by increasing airflow over the
module. To enhance system reliability, the power
module should always be operated below the maximum
operating temperature. If the temperature exceeds the
maximum module temperature, reliability of the unit may
be affected.
in
most
electronics
the
wind
tunnel
Note: Wind Tunnel Test Setup Figure Dimensions are in millimeters and (Inches)
MODULE
AIR FLOW
12.7 (0.5”)
25.4 (1.0”)
50.8 (2.0”)
FACING PWB
PWB
AIR VELOCITY
AND AMBIENT
TEMPERATURE
MEASURED BELOW
THE MODULE
Figure 43:
Wind tunnel test setup
THERMAL CURVES
DNS04S0A0S06(Standard) Output Current vs. Ambient Temperature and Air Velocity
@ Vin=5V, Vout = 1.5V(Either Orientation)
Output Current(A)
0
1
2
3
4
5
6
7
25
35
45
55
65
75
85
Ambient Temperature (
℃
)
Natural
Convection
Figure 45:
Output current vs. ambient temperature and air
velocity@Vin=5V, Vout=3.3V(Either Orientation)
DNS04S0A0S06(Standard) Output Current vs. Ambient Temperature and Air Velocity
@ Vin=5V, Vout = 3.3V(Either Orientation)
Output Current(A)
0
1
2
3
4
5
6
7
25
35
45
55
65
75
85
Ambient Temperature (
℃
)
Natural
Convection
Figure 44:
Temperature measurement location
The allowed maximum hot spot temperature is defined at 127
℃
相關PDF資料 |
PDF描述 |
|---|---|
| DPS-180KB-4 | Complies with TFX12V |
| DPS-200PB-127 | Complies with ATX 12V V1.1 |
| DPS-200PB-143 | Complies with SFX 12V V2.1 |
| DPS-220AB | Application: Desktop PC |
| DPS-230GB-1 | Application: Desktop PC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DNS10S0A0S20NFB | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Non-Isolated Point of Load DC/DC Power Modules: 8.3-14Vin, 0.75-5.0V/20A out |
| DNS10S0A0S20NFD | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Non-Isolated Point of Load DC/DC Power Modules: 8.3-14Vin, 0.75-5.0V/20A out |
| DNS10S0A0S20PFB | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Non-Isolated Point of Load DC/DC Power Modules: 8.3-14Vin, 0.75-5.0V/20A out |
| DNS10S0A0S20PFD | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Non-Isolated Point of Load DC/DC Power Modules: 8.3-14Vin, 0.75-5.0V/20A out |
| DNS12S0A0R10NFA | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Delphi DNM, Non-Isolated Point of Load DC/DC Power Modules: 2.8-5.5Vin, 0.75-3.3V/10A out |
發布緊急采購，3分鐘左右您將得到回復。