- 您現在的位置：買賣IC網 > PDF目錄379101 > CYWM6935PAEC (Cypress Semiconductor Corp.) WirelessUSB⑩ LR+PA Radio Module PDF資料下載
參數資料
| 型號： | CYWM6935PAEC |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | WirelessUSB⑩ LR+PA Radio Module |
| 中文描述： | ⑩輕的WirelessUSB無線電功率放大器模塊 |
| 文件頁數： | 5/10頁 |
| 文件大?。?/td> | 385K |
| 代理商： | CYWM6935PAEC |
PRELIMINARY
CYWM6935PAEC
Document #: 001-07822 Rev. **
Page 5 of 10
4.0
Module Certification Detail
The CYWM6935PAEC Radio Module is a device that
transmits and receives radio signals in accordance with the
spectrum regulations for the 2.4-GHz unlicensed frequency
range. Regional regulatory agency approval may be required
to operate CYWM6935PAEC throughout the world.
Cypress Semiconductor Corporation has obtained regulatory
approvals for the CYWM6935PAEC to be used in specific
countries. CYWM6935PAEC was approved under the
“Modular Approval (MA) to the OEM.
The MA Grant provides that device manufacturers who incor-
porate CYWM6935PAEC as tested and approved can be
relieved from having to perform the Radio Regulatory certifi-
cation portion of the respective agency certification.
The MA Grant is valid only in countries
[1.]
that recognize the
MA Grant certification process; the USA, Canada, Belgium,
Denmark, France, Finland, Germany, Italy, Netherlands,
Spain, Sweden, UK.
4.1
ule Approval
In order to be able to take advantage of Cypress’s modular
certification in an end product, the following must be ensured:
1. Correct Application.
2. Correct Installation.
3. Correct labeling.
Eligibility Requirements for Regulatory Mod-
4.1.1
There are two types of application considered for
CYWM6935PAEC modules. The application types are defined
below:
a. Fixed Application:
Module is in a permanent location and has at least 2m
separation from the human body.
b. Mobile Application:
Module can be relocated and will have at least 20 cm
separation from the human body.
Correct Application:
4.1.2
Correct Installation:
—Modules cannot be modified in any way.
—Modules must be used only in the operating range spec-
ified in the data sheets.
—Modules cannot be located within 20 cm of another in-
tentional radiator in the system.
—
It is recommended to use Antenna-A or equivalent. The
antenna gain and form factor should be equivalent to
Antenna-A.
—Must guarantee that end user cannot easily change an-
tenna.
Note:
Sidestepping these requirements is possible with
additional testing and/or recertification. However, modular
approval would no longer apply.
4.1.3
If an end device containing a WirelessUSB CYWM6935PAEC
Radio Module will be sold or used in the USA, the enclosure
of the product must display a label with the following basic
elements:
Correct Labeling:
If an end device containing a WirelessUSB CYWM6935PAEC
Radio Module will be sold or used in Europe, the enclosure of
the product must display a label with the following basic
elements:
If an end device containing WirelessUSB CYWM6935PAEC
Radio Module will be sold or used in Canada, the enclosure of
the product must display a label with the following basic
elements:
As of March 2006, Japan does not recognize the “Modular
Approval” certification. Regulatory certification for Japan
(TELEC) must be acquired through typical approval proce-
dures. These approvals are the sole responsibility of the OEM.
Note:
Even with modular approval, the end device still has to
be tested for digital emissions compliance with all agencies as
an electronic device. The modular approval only eliminates the
need to test for compliance on RF transmissions.
4.2
Electronic device manufacturers using Cypress’s Modular
Approval are required to follow the below mentioned labeling
practice on the container in which the device is marketed or in
the product user’s guide. This should be in accompaniment
with other regulatory information. The text may be disbursed
according to language or geographic regions if desired, but the
exact text shown below must be maintained.
User Guide Information
4.2.1
The device shall bear the following statement in a conspicuous
location:
United States of America requirements:
Contains FCC ID: R8KUGWN2USHN33
0122
Canadian Cert No IC: 5125A-UGWN2US
This product contains Cypress WirelessUSB module
相關PDF資料 |
PDF描述 |
|---|---|
| CYWUSB6953-48LFC | WirelessUSB PRoC Flash Programmable MCU + Radio |
| CZ50CPU | 8-Bit Microprocessor Megafunction |
| CZ80CPU | 8-Bit Microprocessor Megafunction |
| CZ80PIO | Hereinafter Referred to As PIO, is a Dual-Port Device |
| D048C033T015M1N | DC-DC Converters Quarter Brick, 48 Vin Family |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CYWMC60123-PVXC | 制造商:Cypress Semiconductor 功能描述: |
| CYWUSB6932 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:WirelessUSB⑩ LS 2.4-GHz DSSS Radio SoC |
| CYWUSB6932_05 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:WirelessUSB⑩ LS 2.4-GHz DSSS Radio SoC |
| CYWUSB6932-28SEC | 功能描述:IC WIRELESS USB 2.4GHZ 28-SOIC RoHS:否 類別:RF/IF 和 RFID >> RF 收發器 系列:WirelessUSB™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:30 系列:- 頻率:4.9GHz ~ 5.9GHz 數據傳輸率 - 最大:54Mbps 調制或協議:* 應用:* 功率 - 輸出:-3dBm 靈敏度:- 電源電壓:2.7 V ~ 3.6 V 電流 - 接收:* 電流 - 傳輸:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 工作溫度:-25°C ~ 85°C 封裝/外殼:68-TQFN 裸露焊盤 包裝:管件 |
| CYWUSB6932-48LFXC | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:WirelessUSB⑩ LS 2.4-GHz DSSS Radio SoC |
發布緊急采購，3分鐘左右您將得到回復。