- 您現在的位置：買賣IC網 > PDF目錄67392 > CX24118A-12Z (NXP SEMICONDUCTORS) Advanced Modulation Digital Satellite Tuner PDF資料下載
參數資料
| 型號： | CX24118A-12Z |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 消費家電 |
| 英文描述： | Advanced Modulation Digital Satellite Tuner |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQCC36 |
| 封裝： | 6 X 6 MM, 0.85 MM HEIGHT, PLASTIC, SOT1092-1, HVQFN-36 |
| 文件頁數： | 35/45頁 |
| 文件大?。?/td> | 494K |
| 代理商： | CX24118A-12Z |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁
40
XMEGA A1U [DATASHEET]
Atmel-8385H-AVR-ATxmega64A1U-128A1U-Datasheet–AVR–04/2014
21.
USB – Universal Serial Bus Interface
21.1
Features
One USB 2.0 full speed (12Mbps) and low speed (1.5Mbps) device compliant interface
Integrated on-chip USB transceiver, no external components needed
16 endpoint addresses with full endpoint flexibility for up to 31 endpoints
One input endpoint per endpoint address
One output endpoint per endpoint address
Endpoint address transfer type selectable to
Control transfers
Interrupt transfers
Bulk transfers
Isochronous transfers
Configurable data payload size per endpoint, up to 1023 bytes
Endpoint configuration and data buffers located in internal SRAM
Configurable location for endpoint configuration data
Configurable location for each endpoint's data buffer
Built-in direct memory access (DMA) to internal SRAM for:
Endpoint configurations
Reading and writing endpoint data
Ping-pong operation for higher throughput and double buffered operation
Input and output endpoint data buffers used in a single direction
CPU/DMA controller can update data buffer during transfer
Multi packet transfer for reduced interrupt load and software intervention
Data payload exceeding maximum packet size is transferred in one continuous transfer
No interrupts or software interaction on packet transaction level
Transaction complete FIFO for workflow management when using multiple endpoints
Tracks all completed transactions in a first-come, first-served work queue
Clock selection independent of system clock source and selection
Minimum 1.5MHz CPU clock required for low speed USB operation
Minimum 12MHz CPU clock required for full speed operation
Connection to event system
On chip debug possibilities during USB transactions
21.2
Overview
The USB module is a USB 2.0 full speed (12Mbps) and low speed (1.5Mbps) device compliant interface.
The USB supports 16 endpoint addresses. All endpoint addresses have one input and one output endpoint, for a total of
31 configurable endpoints and one control endpoint. Each endpoint address is fully configurable and can be configured
for any of the four transfer types; control, interrupt, bulk, or isochronous. The data payload size is also selectable, and it
supports data payloads up to 1023 bytes.
No dedicated memory is allocated for or included in the USB module. Internal SRAM is used to keep the configuration for
each endpoint address and the data buffer for each endpoint. The memory locations used for endpoint configurations
and data buffers are fully configurable. The amount of memory allocated is fully dynamic, according to the number of
endpoints in use and the configuration of these. The USB module has built-in direct memory access (DMA), and will
read/write data from/to the SRAM when a USB transaction takes place.
To maximize throughput, an endpoint address can be configured for ping-pong operation. When done, the input and
output endpoints are both used in the same direction. The CPU or DMA controller can then read/write one data buffer
while the USB module writes/reads the others, and vice versa. This gives double buffered communication.
相關PDF資料 |
PDF描述 |
|---|---|
| DAMM | FEMALE; MALE, D SUBMINIATURE CONNECTOR, SOLDER, PLUG; RECEPTACLE |
| DBMM | FEMALE; MALE, D SUBMINIATURE CONNECTOR, SOLDER, PLUG; RECEPTACLE |
| DCMM | FEMALE; MALE, D SUBMINIATURE CONNECTOR, SOLDER, PLUG; RECEPTACLE |
| DDMM | FEMALE; MALE, D SUBMINIATURE CONNECTOR, SOLDER, PLUG; RECEPTACLE |
| DEMM | FEMALE; MALE, D SUBMINIATURE CONNECTOR, SOLDER, PLUG; RECEPTACLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CX24118A-12Z,518 | 功能描述:調諧器 IC SATELLITE TUNER DGTL RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| CX24118A-12Z,557 | 功能描述:調諧器 IC SATELLITE TUNER DGTL RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| CX24123 | 制造商:CONEXANT 制造商全稱:CONEXANT 功能描述:Demodulator and FEC Decoder Low-power QPSK demodulator for worldwide satellite set-top box applications |
| CX24123-11,518 | 功能描述:IC DEMODULATOR/DECODER 64-TQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| CX24123-11,557 | 功能描述:IC DEMODULATOR/DECODER 64-TQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
發布緊急采購，3分鐘左右您將得到回復。