- 您現在的位置：買賣IC網 > PDF目錄379972 > COP8SGK840V9 (National Semiconductor Corporation) LP3962/LP3965 1.5A Fast Ultra Low Dropout Linear Regulators; Package: TO-263; No of Pins: 5 PDF資料下載
參數資料
| 型號： | COP8SGK840V9 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | LP3962/LP3965 1.5A Fast Ultra Low Dropout Linear Regulators; Package: TO-263; No of Pins: 5 |
| 中文描述： | 8位的CMOS基于ROM和OTP微控制器具有8K到32K的內存，2個比較器和USART |
| 文件頁數： | 18/62頁 |
| 文件大?。?/td> | 913K |
| 代理商： | COP8SGK840V9 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁
5.0 Functional Description
(Continued)
programmed to 0 for all other applications.
Enable full port F capability.
HALT mode disabled.
HALT mode enabled.
= 0
= 1
= 0
Bit 0
5.6 USER STORAGE SPACE IN EPROM
The ECON register is outside of the normal address range of
the ROM and can not be accessed by the executing soft-
ware.
The COP8 assembler defines a special ROM section type,
CONF, into which the ECON may be coded. Both ECON and
User Data are programmed automatically by programmers
that are certified by National.
The following examples illustrate the declaration of ECON
and the User information.
Syntax:
[label:] .sect
econ, conf
.db
value
;1 byte,
;configures options
<user information>
.endsect
; up to 8 bytes
Example: The following sets a value in the ECON register
and User Identification for a COP8SGR728M7. The ECON
bit values shown select options: Power-on enabled, Security
disabled, Crystal oscillator with on-chip bias disabled,
WATCHDOG enabled and HALT mode enabled.
.sect
econ, conf
.db
0x55
;por, xtal, wd, halt
.db
'my v1.00' ;user data declaration
.endsect
.db
5.7 OTP SECURITY
The device has a security feature that, when enabled, pre-
vents external reading of the OTP program memory. The
security bit in the ECON register determines, whether secu-
rity is enabled or disabled. If the security feature is disabled,
the contents of the internal EPROM may be read.
If the security feature is enabled, then any attempt to
externally read the contents of the EPROM will result in
the value FF Hex being read from all program locations
Under no circumstances can a secured part be read.
In
addition, with the security feature enabled, the write opera-
tion to the EPROM program memory and ECON register is
inhibited. The ECON register is readable regardless of the
state of the security bit. The security bit, when set,
cannot
be erased,
even in windowed packages.
If the security bit
is set in a device in a windowed package, that device may be
erased but will not be further programmable.
If security is being used, it is recommended that all other bits
in the ECON register be programmed first. Then the security
bit can be programmed.
5.8 ERASURE CHARACTERISTICS
The erasure characteristics of the device are such that era-
sure begins to occur when exposed to light with wavelengths
shorter than approximately 4000 Angstroms (). It should be
noted that sunlight and certain types of fluorescent lamps
have wavelengths in the 3000 - 4000 range.
After programming, opaque labels should be placed over the
window of windowed devices to prevent unintentional era-
sure. Covering the window will also prevent temporary func-
tional failure due to the generation of photo currents.
The recommended erasure procedure for windowed devices
is exposure to short wave ultraviolet light which has a wave-
length of 2537 Angstroms (). The integrated dose (i.e. UV
intensity X exposure time) for erasure should be a minimum
of 15W-sec/cm
2
.
5.9 RESET
The devices are initialized when the RESET pin is pulled low
or the On-chip Power-On Reset is enabled.
The following occurs upon initialization:
Port L: TRI-STATE (High Impedance Input)
Port C: TRI-STATE (High Impedance Input)
Port G: TRI-STATE (High Impedance Input)
Port F: TRI-STATE (High Impedance Input)
Port D: HIGH
PC: CLEARED to 0000
PSW, CNTRL and ICNTRL registers: CLEARED
SIOR:
UNAFFECTED after RESET with power already applied
RANDOM after RESET at power-on
T2CNTRL: CLEARED
T3CNTRL: CLEARED
Accumulator, Timer 1, Timer 2 and Timer 3:
RANDOM after RESET with crystal clock option
(power already applied)
UNAFFECTED after RESET with R/C clock option
(power already applied)
RANDOM after RESET at power-on
WKEN, WKEDG: CLEARED
WKPND: RANDOM
SP (Stack Pointer):
Initialized to RAM address 06F Hex
B and X Pointers:
UNAFFECTED after RESET with power already applied
RANDOM after RESET at power-on
S Register: CLEARED
RAM:
UNAFFECTED after RESET with power already applied
RANDOM after RESET at power-on
USART:
PSR, ENU, ENUR, ENUI: Cleared except the TBMT bit
which is set to one.
COMPARATORS:
CMPSL; CLEARED
WATCHDOG (if enabled):
10131713
FIGURE 8. Reset Logic
C
www.national.com
18
相關PDF資料 |
PDF描述 |
|---|---|
| COP8SGK844N9 | LP3963/LP3966 3A Fast Ultra Low Dropout Linear Regulators; Package: TO-220; No of Pins: 5 |
| COP8SGK844Q3 | 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART |
| COP8SGK844Q6 | 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART |
| COP8SGK844Q7 | 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART |
| COP8SGK844Q8 | 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART |
相關代理商/技術參數 |
參數描述 |
|---|---|
| COP8SGR728M7 | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8SGR728M7/NOPB | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8SGR728M8 | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8SGR728M8/NOPB | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8SGR728N8 | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。