• 參數資料
      型號: COP8SGE528V7
      廠商: National Semiconductor Corporation
      英文描述: LMX2354 PLLatinum Fractional N RF/ Integer N IF Dual Low Power Frequency Synthesizer LMX2354 2.5 GHz/550 MHz; Package: TSSOP; No of Pins: 24
      中文描述: 8位的CMOS基于ROM和OTP微控制器具有8K到32K的內存,2個比較器和USART
      文件頁數: 43/62頁
      文件大?。?/td> 913K
      代理商: COP8SGE528V7
      12.0 MICROWIRE/PLUS
      (Continued)
      arrangement with the internal clock source is called the
      Master
      mode
      of
      operation.
      MICROWIRE/PLUS arrangement with an external shift clock
      is called the Slave mode of operation.
      The CNTRL register is used to configure and control the
      MICROWIRE/PLUS mode. To use the MICROWIRE/PLUS,
      the MSEL bit in the CNTRL register is set to one. In the
      master mode, the SK clock rate is selected by the two bits,
      SL0 and SL1, in the CNTRL register. Table 10 details the
      different clock rates that may be selected.
      Similarly,
      operating
      the
      TABLE 10. MICROWIRE/PLUS
      Master Mode Clock Select
      SL1
      0
      0
      1
      SL0
      0
      1
      x
      SK Period
      2 x t
      C
      4 x t
      C
      8 x t
      C
      Where t
      C
      is the instruction cycle clock
      12.1 MICROWIRE/PLUS OPERATION
      Setting the BUSY bit in the PSW register causes the
      MICROWIRE/PLUS to start shifting the data. It gets reset
      when eight data bits have been shifted. The user may reset
      the BUSY bit by software to allow less than 8 bits to shift. If
      enabled, an interrupt is generated when eight data bits have
      been shifted. The device may enter the MICROWIRE/PLUS
      mode either as a Master or as a Slave. Figure 28shows how
      two microcontroller devices and several peripherals may be
      interconnected using the MICROWIRE/PLUS arrangements.
      WARNING
      The SIO register should only be loaded when the SK clock is
      in the idle phase. Loading the SIO register while the SK clock
      is in the active phase, will result in undefined data in the SIO
      register.
      Setting the BUSY flag when the input SK clock is in the
      active phase while in the MICROWIRE/PLUS is in the slave
      mode may cause the current SK clock for the SIO shift
      register to be narrow. For safety, the BUSY flag should only
      be set when the input SK clock is in the idle phase.
      12.1.1 MICROWIRE/PLUS Master Mode Operation
      In the MICROWIRE/PLUS Master mode of operation the
      shift clock (SK) is generated internally. The MICROWIRE
      Master always initiates all data exchanges. The MSEL bit in
      the CNTRL register must be set to enable the SO and SK
      functions onto the G Port. The SO and SK pins must also be
      selected as outputs by setting appropriate bits in the Port G
      configuration register. In the slave mode, the shift clock
      stops after 8 clock pulses. Table 11 summarizes the bit
      settings required for Master mode of operation.
      10131732
      FIGURE 28. MICROWIRE/PLUS Application
      C
      www.national.com
      43
      相關PDF資料
      PDF描述
      COP8SGE528V8 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART
      COP8SGE540D8 8-Bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and USART
      COP8SGE540D9 LMX2364 2.6 GHz PLLatinum Fractional RF Frequency Synthesizer with 850 MHz Integer IF Frequency Synthesizer; Package: LAMINATE UCSP; No of Pins: 24
      COP8SGE540L8 LMX2364 2.6 GHz PLLatinum Fractional RF Frequency Synthesizer with 850 MHz Integer IF Frequency Synthesizer; Package: TSSOP; No of Pins: 24
      COP8SGE540L9 LMX2364 2.6 GHz PLLatinum Fractional RF Frequency Synthesizer with 850 MHz Integer IF Frequency Synthesizer; Package: TSSOP; No of Pins: 24
      相關代理商/技術參數
      參數描述
      COP8SGE728M7/NOPB 制造商:Texas Instruments 功能描述:MCU 8-Bit COP8 CISC 8KB EPROM 3.3V/5V 28-Pin SOIC W Rail
      COP8SGE728M8 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
      COP8SGE728M8/63SN 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
      COP8SGE728M8/NOPB 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
      COP8SGE728N8 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT