- 您現在的位置：買賣IC網 > PDF目錄9130 > CDC2509BPWRG4 (Texas Instruments)IC 3.3V PLL CLK-DRVR 24-TSSOP PDF資料下載
參數資料
| 型號： | CDC2509BPWRG4 |
| 廠商： | Texas Instruments |
| 文件頁數： | 1/14頁 |
| 文件大小： | 0K |
| 描述： | IC 3.3V PLL CLK-DRVR 24-TSSOP |
| 標準包裝： | 2,000 |
| 類型： | PLL 時鐘驅動器 |
| PLL： | 帶旁路 |
| 輸入： | LVTTL |
| 輸出： | LVTTL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:9 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 125MHz |
| 除法器/乘法器： | 無/無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 帶卷 (TR) |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
CDC2509B
3.3V PHASELOCK LOOP CLOCK DRIVER
SCAS613C SEPTEMBER 1998 REVISED DECEMBER 2004
1
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
D Use CDCVF2509A as a Replacement for
this Device
D Designed to Meet PC SDRAM Registered
DIMM Specification
D Spread Spectrum Clock Compatible
D Operating Frequency 25 MHz to 125 MHz
D Phase Error Time Minus Jitter at 66 MHz to
100 MHz Is
±150 ps
D Jitter (peak peak) at 66 MHz to 100 MHz Is
±80 ps
D Jitter (cycle cycle) at 66 MHz to 100 MHz
Is |100 ps|
D Available in Plastic 24-Pin TSSOP
D Phase-Lock Loop Clock Distribution for
Synchronous DRAM Applications
D Distributes One Clock Input to One Bank of
Five and One Bank of Four Outputs
D Separate Output Enable for Each Output
Bank
D External Feedback (FBIN) Terminal Is Used
to Synchronize the Outputs to the Clock
Input
D On-Chip Series Damping Resistors
D No External RC Network Required
D Operates at 3.3 V
description
The CDC2509B is a high-performance, low-skew, low-jitter, phase-lock loop (PLL) clock drivers. They use a PLL
to precisely align, in both frequency and phase, the feedback (FBOUT) output to the clock (CLK) input signal.
They are specifically designed for use with synchronous DRAMs. The CDC2509B operates at 3.3-V VCC. They
also provide integrated series-damping resistors that make it ideal for driving point-to-point loads.
One bank of five outputs and one bank of four outputs provide nine low-skew, low-jitter copies of CLK. Output
signal duty cycles are adjusted to 50%, independent of the duty cycle at CLK. Each bank of outputs is enabled
or disabled separately via the control (1G and 2G) inputs. When the G inputs are high, the outputs switch in
phase and frequency with CLK; when the G inputs are low, the outputs are disabled to the logic-low state.
Unlike many products containing PLLs, the CDC2509B does not require external RC networks. The loop filter
for the PLL is included on-chip, minimizing component count, board space, and cost.
Because it is based on PLL circuitry, the CDC2509B requires a stabilization time to achieve phase lock of the
feedback signal to the reference signal. This stabilization time is required, following power up and application
of a fixed-frequency, fixed-phase signal at CLK, and following any changes to the PLL reference or feedback
signals. The PLL can be bypassed for test purposes by strapping AVCC to ground.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright
2001 2004, Texas Instruments Incorporated
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
CLK
AVCC
VCC
2Y0
2Y1
GND
2Y2
2Y3
VCC
2G
FBIN
1
2
3
4
5
6
7
8
9
10
11
12
AGND
VCC
1Y0
1Y1
1Y2
GND
1Y3
1Y4
VCC
1G
FBOUT
24
23
22
21
20
19
18
17
16
15
14
13
PW PACKAGE
(TOP VIEW)
相關PDF資料 |
PDF描述 |
|---|---|
| GTC020R-24-10P | CONN RCPT 7POS BOX MNT W/PINS |
| M83723/72W22558 | CONN RCPT 55POS WALL MT W/PINS |
| MS3456W22-7P | CONN PLUG 1POS STRAIGHT W/PINS |
| MS27474E18F96P | CONN RCPT 9POS JAM NUT W/PINS |
| X9241AWPI | IC XDCP QUAD 4X10K EE 20-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDC2509BSTE-E | 功能描述:IC 3.3V PLL CLOCK DVR 24TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| CDC2509C | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3.3-V PHASE-LOCK LOOP CLOCK DRIVER |
| CDC2509CPW | 功能描述:時鐘驅動器及分配 1-to-9 PLL Clock Driver RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| CDC2509CPWG4 | 功能描述:時鐘驅動器及分配 1-to-9 PLL Clock Driver RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| CDC2509CPWR | 功能描述:時鐘驅動器及分配 3.3V Clock RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。