- 您現在的位置：買賣IC網 > PDF目錄366752 > CAT661ESA-TE13 High Frequency 100mA CMOS Charge Pump, Inverter/Doubler PDF資料下載
參數資料
| 型號： | CAT661ESA-TE13 |
| 英文描述： | High Frequency 100mA CMOS Charge Pump, Inverter/Doubler |
| 中文描述： | 高頻100mA的CMOS電荷泵，逆變器/倍增 |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 488K |
| 代理商： | CAT661ESA-TE13 |
CAT661
8
Doc. No. 5003, Rev. J
Figure 5. CAT661 Block Diagram
+
C2
V+
(8)
2
OSC
BOOST/FC
8x
(1)
OSC
(7)
LV
(6)
CLOSED WHEN
V+ > 3.0V
GND
(3)
CAP-
(4)
C1
+
CAP+
(2)
SW2
SW1
Ο
Ο
VOUT
(5)
(N) = Pin Number
OSCILLATOR FREQUENCY CONTROL
The switching frequency can be raised, lowered or driven from an external source. Figure 6 shows a functional diagram
of the oscillator circuit.
The CAT661 oscillator has four control modes:
BOOST/FC Pin Connection
OSC Pin Connection
Nominal Oscillator Frequency
Open
Open
25kHz
BOOST/FC= V+
Open
135kHz
Open or BOOST/FC= V+
External Capacitor
—
Open
External Clock
Frequency of external clock
If BOOST/FC and OSC are left floating (Open), the
nominal oscillator frequency is 25kHz. The pump
frequency is one-half the oscillator frequency.
By connecting the BOOST/FC pin to V+, the charge and
discharge currents are increased, and the frequency is
increased by approximately 6 times. Increasing the
frequency will decrease the output impedance and ripple
currents. This can be an advantage at high load currents.
Increasing the frequency raises quiescent current but
allows smaller capacitance values for C1 and C2.
If pin 7, OSC, is loaded with an external capacitor the
frequency is lowered. By using the BOOST/FC pin and
an external capacitor at OSC, the operating frequency
can be set.
Note that the frequency appearing at CAP+ or CAP- is
one-half that of the oscillator.
Driving the CAT661 from an external frequency source
can be easily achieved by driving Pin 7 and leaving the
BOOST pin open, as shown in figure 6. The output
current from Pin 7 is small, typically 1
μ
A to 8
μ
A, so a
CMOS can drive the OSC pin. For 5V applications, a TTL
logic gate can be used if an external 100k
pull-up
resistor is used as shown in figure 7.
相關PDF資料 |
PDF描述 |
|---|---|
| CAT661EVA | POT 200K OHM 3/8 SQ CERM SL MT |
| CAT661EVA-TE13 | High Frequency 100mA CMOS Charge Pump, Inverter/Doubler |
| CAT71C256LKI-85 | 72-Mbit DDR-II SRAM 2-Word Burst Architecture |
| CAT71C256LPI-85 | 72-Mbit DDR-II SRAM 2-Word Burst Architecture |
| CAT808 | Low-Power Precision Voltage Detector |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT661EVA | 制造商:ON Semiconductor 功能描述: 制造商:ON Semiconductor 功能描述:CHARGE PUMP VOLTAGE CONVERTER - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: 制造商:Catalyst Semiconductor 功能描述: |
| CAT661EVA-G | 制造商:ON Semiconductor 功能描述:CAT661: Charge Pump Voltage Converter SOIC8 |
| CAT661EVA-GT3 | 功能描述:電荷泵 CHG PUMP VOLT CONVERTER RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| CAT661EVA-T3 | 功能描述:IC REG MULTI CONFIG 0.1A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| CAT661EVA-TE13 | 制造商:CATALYST 制造商全稱:Catalyst Semiconductor 功能描述:High Frequency 100mA CMOS Charge Pump, Inverter/Doubler |
發布緊急采購，3分鐘左右您將得到回復。