- 您現在的位置：買賣IC網 > PDF目錄366746 > CAT5251UI-50TE13 Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface PDF資料下載
參數資料
| 型號： | CAT5251UI-50TE13 |
| 元件分類： | 數字電位計 |
| 英文描述： | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
| 中文描述： | 四數字可編程電位（民進黨）與256水龍頭和SPI接口 |
| 文件頁數： | 8/15頁 |
| 文件大?。?/td> | 95K |
| 代理商： | CAT5251UI-50TE13 |
8
CAT5251
Document No. 2017, Rev. D
INSTRUCTION AND REGISTER
DESCRIPTION
DEVICE TYPE / ADDRESS BYTE
The first byte sent to the CAT5251 from the master/
processor is called the Device Address Byte. The most
significant four bits of the Device Type address are a
device type identifier. These bits for the CAT5251 are
fixed at 0101[B] (refer to Table 1).
The two least significant bits in the slave address byte,
A1 - A0, are the internal slave address and must match
the physical device address which is defined by the state
of the A1 - A0 input pins for the CAT5251 to successfully
continue the command sequence. Only the device which
slave address matches the incoming device address
sent by the master executes the instruction. The A1 - A0
inputs can be actively driven by CMOS input signals or
tied to V
CC
or V
SS
. The remaining two bits in the device
address byte must be set to 0.
INSTRUCTION BYTE
The next byte sent to the CAT5251 contains the instruction
and register pointer information. The four most significant
bits used provide the instruction opcode I3-I0. The R1
and R0 bits point to one of the four data registers of each
associated potentiometer. The least two significant bits
point to one of four Wiper Control Registers. The format
is shown in Table 2.
Table 1. Identification Byte Format
ID3
0
(MSB)
ID2
1
ID1
0
ID0
1
0
0
A1
A0
(LSB)
Device Type
Identifier
Slave Address
Table 2. Instruction Byte Format
I3
I2
I1
I0
R1
R0
P1
P0
(MSB)
(LSB)
Instruction
Opcode
Data Register
Selection
WCR/Pot Selection
Data Register Selected
R1
R0
DR0
0
0
DR1
0
1
DR2
1
0
DR3
1
1
Data Register Selection
相關PDF資料 |
PDF描述 |
|---|---|
| CAT5251 | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
| CAT5251JI-50TE13 | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
| CAT5251WI-50TE13 | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
| CAT5251YI-50TE13 | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
| CAT5251YI-00TE13 | Quad Digitally Programmable Potentiometer (DPP) with 256 Taps and SPI Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT5251WI00 | 制造商:ON Semiconductor 功能描述:DPP, NV, QUAD 256 TAPS, SPI - Rail/Tube |
| CAT5251WI-00 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Catalyst Semiconductor 功能描述: |
| CAT5251WI-00-T1 | 功能描述:數字電位計 IC DPP NV QUAD 256 TAP SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5251WI50 | 功能描述:數字電位計 IC Ind Temp 50K Up/Dwn Quad 256-Tap SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5251WI-50 | 制造商:ON Semiconductor 功能描述:IC DIGITAL POT 50KOHM 256 QUAD SOIC-24 |
發布緊急采購，3分鐘左右您將得到回復。