- 您現在的位置：買賣IC網 > PDF目錄169494 > CAT1162J-42TE13 (ON SEMICONDUCTOR) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 PDF資料下載
參數資料
| 型號： | CAT1162J-42TE13 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封裝： | SOIC-8 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 77K |
| 代理商： | CAT1162J-42TE13 |
6
CAT1161/2
Doc. No. 3002, Rev. D
falls below (power down) VTH or until VCC reaches the
reset threshold (power up) VTH. Any attempt to access
the internal EEPROM is not recognized and an ACK will
not be sent on the SDA line when RESET or
RESET
is active.
Reset Threshold Voltage
The CAT1161/2 is offered with five reset threshold
voltage ranges. They are 4.50-4.75V, 4.25-4.50V, 3.00-
3.15V, 2.85-3.00V and 2.55-2.70V.
Hardware Data Protection
The CAT1161/2 is designed with the following hardware
data protection features to provide a high degree of data
integrity.
(1) The CAT1161/2 features a WP pin. When the WP pin
is tied high the entire memory array becomes write
protected (read only).
(2) The VCC sense provides write protection when VCC
falls below the reset threshold value (VTH). The VCC lock
out inhibits writes to the serial EEPROM whenever VCC
tHIGH
SCL
SDA IN
SDA OUT
tLOW
tF
tLOW
tR
tBUF
tSU:STO
tSU:DAT
tHD:DAT
tHD:STA
tSU:STA
tAA
tDH
Figure 2. Bus Timing
tWR
STOP
CONDITION
START
CONDITION
ADDRESS
ACK
8TH BIT
BYTE n
SCL
SDA
Figure 3. Write Cycle Timing
START BIT
SDA
STOP BIT
SCL
Figure 4. Start/Stop Timing
Main Menu
相關PDF資料 |
PDF描述 |
|---|---|
| CAT1162JI-45TE13 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| CAT1232LPGW | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO16 |
| CAT1320PI-45TDFN | Supervisory Circuits with I2C Serial 32K CMOS EEPROM |
| CAT1320JI-45TDFN | Supervisory Circuits with I2C Serial 32K CMOS EEPROM |
| CAT1320UI-45TDFN | Supervisory Circuits with I2C Serial 32K CMOS EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT1162J-45 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162J-45 TE13 | 制造商:ON Semiconductor 功能描述:Processor Supervisor 3V/3.3V/5V 8-Pin SOIC N T/R |
| CAT1162JI-28 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162JI-42 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162L-25 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。