參數資料
型號: C515C
廠商: SIEMENS AG
元件分類: 8位微控制器
英文描述: 8-Bit CMOS Microcontroller
中文描述: 8位CMOS微控制器
文件頁數: 48/96頁
文件大?。?/td> 1285K
代理商: C515C
C515C
Data Sheet
44
2003-02
The
Cyclic Redundancy Check Register (CRC)
generates the Cyclic Redundancy
Check code to be transmitted after the data bytes and checks the CRC code of incoming
messages. This is done by dividing the data stream by the code generator polynomial.
The
Error Management Logic (EML)
is responsible for the fault confinement of the
CAN device. Its counters, the Receive Error Counter and the Transmit Error Counter, are
incremented and decremented by commands from the Bit Stream Processor. According
to the values of the error counters, the CAN controller is set into the states error
active
,
error
passive
and busoff.
The
Bit Timing Logic (BTL)
monitors the busline input RXDC and handles the busline
related bit timing according to the CAN protocol. The BTL synchronizes on a
recessive
to
dominant
busline transition at
Start of Frame
(hard synchronization) and on any further
recessive
to
dominant
busline transition, if the CAN controller itself does not transmit a
dominant
bit (resynchronization). The BTL also provides programmable time segments
to compensate for the propagation delay time and for phase shifts and to define the
position of the Sample Point in the bit time. The programming of the BTL depends on the
baudrate and on external physical delay times.
The
Intelligent Memory
(CAM/RAM array) provides storage for up to 15 message
objects of maximum 8 data bytes length. Each of these objects has a unique identifier
and its own set of control and status bits. After the initial configuration, the Intelligent
Memory can handle the reception and transmission of data without further CPU actions.
Switch-off Capability of the CAN Controller (C515C-8E only)
For power consumption reasons, the on-chip CAN controller in the C515C-8E can be
switched off by setting bit CSWO (bit 2) in SFR SYSCON. When the CAN controller is
switched off its clock signal is turned off and the operation of the CAN controller is
stopped. This switch-off state of the CAN controller is equal to its state in software power
down mode. After clearing bit CSWO again the CAN controller has to be reconfigured.
相關PDF資料
PDF描述
C517 8-bit CMOS MICROCONTROLLER
C517A ECONOLINE: RY & RX - Controllable Output- 1kVDC Isolation- No Heatsink Required- UL94V-0 Package Material- Toroidal Magnetics- No External Components- Fully Encapsulated- Efficiency to 70%
C517A 8-Bit CMOS Microcontroller
C5259F505SV050100A1 5x7 ceramic oscillator
C5259 5x7 ceramic oscillator
相關代理商/技術參數
參數描述
C515C_9711 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
C515C-8E 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
C515C-8EM 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller
C515C8EMCAFXQMA1 制造商:Infineon Technologies AG 功能描述:MCU 8-bit C500 8051 CISC 64KB EPROM 5V 80-Pin MQFP 制造商:Infineon Technologies AG 功能描述:8 BIT OTP - Trays 制造商:Infineon Technologies AG 功能描述:IC MCU 8BIT OTP MQFP-80-1
C515C8EMCAFXUMA1 制造商:Infineon Technologies AG 功能描述:8 BIT OTP - Tape and Reel