- 您現在的位置：買賣IC網 > PDF目錄384160 > BU9831F (Rohm CO.,LTD.) Non-volatile electronic potentiometer PDF資料下載
參數資料
| 型號： | BU9831F |
| 廠商： | Rohm CO.,LTD. |
| 元件分類： | 數字電位計 |
| 英文描述： | Non-volatile electronic potentiometer |
| 中文描述： | 非易失性電子電位器 |
| 文件頁數： | 8/13頁 |
| 文件大?。?/td> | 149K |
| 代理商： | BU9831F |
8
Memory ICs
BU9831 / BU9831F
Timing charts
(1) Writing enabled / disabled
SK
CS
DIO
H
L
H
L
H
L
ENABLE = 1 1
DISABLE = 0 0
1
4
8
12
16
1
1
0
0
0
0
Fig. 11 Writing enabled and disabled
1) When the power supply is turned on, the writing recognition latch is reset in the same way as when the write dis-
able command is executed. The write enable command must be input before the write command is input.
2) Once the write enable command has been set, it remains effective until either the write disable command is input,
or the power supply is turned off.
3) No clocks longer than 16 clocks are required. These will be ignored by the IC if input. The command is received
following the clock input for the eight bits of the address subsequent to input of the operation code. The contents of
the address are not related to either of these commands, however, and will be ignored.
(2) Wiper counter data output (WCR)
SK
CS
DIO
1
1
1
1
1
0
0
0
H
L
H
L
H
L
(DO)
D8
D14
HIGH-Z
HIGH-Z
1
4
8
16
24
t CS
Fig. 12 Wiper counter data output
1) When the Wiper Counter Data Output (WCR) command is received, seven bits of the data at the current wiper
position are output to D8, D9, D10, ..., D14, in sequential order. If a clock of longer than 24 clocks is input, indefinite
data may be output. (For the DIO output, the data may change at the tPD0 and tPD1 time delays, in response to the
internal circuit delay starting from the falling edge of the SK signal. During the tPD0 and tPD1 time internals, data
should be loaded after the tPD time has been assured, in case the previous data is indefinite. Refer to Fig. 10,
Synchronous data I / O timing.)
相關PDF資料 |
PDF描述 |
|---|---|
| BU9929FV | I2C BUS interface, general purpose I/O ports with condition watching function |
| BUB931T | High Voltage Ignition Coil Driver NPN Power Darlington(高壓點火線圈驅動器NPN達林頓功率晶體管) |
| BUF405AFP | HIGH VOLTAGE FAST-SWITCHING NPN POWER TRANSISTORS |
| BUF405A | High Voltage Fast-Switching NPN Power Transistors(高壓快速開關NPN功率晶體管) |
| BUF405AFI | High Voltage Fast-Switching NPN Power Transistors(高壓快速開關NPN功率晶體管) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU9832GUL-W | 制造商:ROHM 制造商全稱:Rohm 功能描述:WL-CSP EEPROM family SPI BUS |
| BU9832GUL-W_10 | 制造商:ROHM 制造商全稱:Rohm 功能描述:WL-CSP EEPROM family SPI BUS |
| BU9832GUL-WE2 | 功能描述:電可擦除可編程只讀存儲器 電可擦除可編程只讀存儲器 Serial-SPI 8Kb RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| BU9833GUL-W | 制造商:ROHM 制造商全稱:Rohm 功能描述:Silicon Monolithic Integrated Circuit |
| BU9833GUL-W_10 | 制造商:ROHM 制造商全稱:Rohm 功能描述:WL-CSP EEPROM family I2C BUS |
發布緊急采購，3分鐘左右您將得到回復。