• <thead id="v9120"></thead>
    <thead id="v9120"></thead>
    <dd id="v9120"><acronym id="v9120"></acronym></dd>
  • <small id="v9120"><noframes id="v9120"><small id="v9120"></small><tfoot id="v9120"><legend id="v9120"><rp id="v9120"></rp></legend></tfoot>
  • 參數資料
    型號: BU-65179F0-450L
    廠商: DATA DEVICE CORP
    元件分類: 微控制器/微處理器
    英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    封裝: 1 X 1 INCH, LOW PROFILE, CERAMIC, QFP-72
    文件頁數: 9/12頁
    文件大?。?/td> 141K
    代理商: BU-65179F0-450L
    6
    Data Device Corporation
    www.ddc-web.com
    BU-65178/65179*/61688*/61689*
    F1 web-09/02-0
    TRANSFORMERS
    In selecting isolation transformers to be used with the Mini-ACE,
    there is a limitation on the maximum amount of leakage induc-
    tance. If this limit is exceeded, the transmitter rise and fall times
    may increase, possibly causing the bus amplitude to fall below
    the minimum level required by MIL-STD-1553. In addition, an
    excessive leakage imbalance may result in a transformer dynam-
    ic offset that exceeds 1553 specifications.
    The maximum allowable leakage inductance is 6.0 H, and
    is measured as follows:
    The
    side
    of
    the
    transformer
    that
    connects
    to
    the
    Mini-ACE is defined as the “primary” winding. If one side of the
    primary is shorted to the primary center-tap, the inductance
    should be measured across the “secondary” (stub side) winding.
    This inductance must be less than 6.0 H. Similarly, if the other
    side of the primary is shorted to the primary center-tap, the
    inductance measured across the “secondary” (stub side) wind-
    ing must also be less than 6.0 H.
    The difference between these two measurements is the
    “differential” leakage inductance. This value must be less than
    1.0 H.
    Beta Transformer Technology Corporation (BTTC), a subsidiary
    of DDC, manufactures transformers in a variety of mechanical
    configurations with the required turns ratios of 1:2.5 direct cou-
    pled, and 1:1.79 transformer coupled. TABLE 3 provides a listing
    of many of these transformers.
    For further information, contact BTTC at 631-244-7393 or at
    www.bttc-beta.com.
    DLP-7014
    SLP-8007
    SLP-8024
    NOT RECOMMENDED
    LPB-5015
    B-3310
    HLP-6015
    Dual epoxy transformer, side by side, surface mount, 0.930" X 0.630", 0.155" max height
    DLP-7115 (see note1)
    Dual epoxy transformer, side by side, surface mount, 1.410" X 0.750", 0.130" max height
    Single metal transformer, hermetically sealed, surface mount, 0.630" X 0.630", 0.175" max height
    B-3261
    HLP-6014
    Dual epoxy transformer, side by side, flat pack, 0.930" X 0.630", 0.155" max height
    Single metal transformer, hermetically sealed, flat pack, 0.630" X 0.630", 0.175" max height
    B-3300
    Dual epoxy transformer, side by side, through-hole, 0.930" X 0.630", 0.155" max height
    TST-9027
    Dual epoxy transformer, twin stacked, flat pack, 0.625" X 0.625", 0.280" max height
    TST-9017
    Dual epoxy transformer, twin stacked, surface mount, 0.625" X 0.625", 0.280" max height
    TST-9007
    Dual epoxy transformer, twin stacked, 0.625" X 0.625", 0.280" max height
    B-3819
    LPB-5014
    Single epoxy transformer, surface mount, hi-temp solder, 0.625" X 0.625", 0.220" max height.
    Single epoxy transformer, flat pack, 0.625" X 0.625", 0.150" max height
    B-3227
    Single epoxy transformer, surface mount, 0.625" X 0.625", 0.275" max height
    B-3231
    Single epoxy transformer, flat pack, 0.625" X 0.625", 0.275" max height
    B-3818
    B-3067
    B-3226
    Single epoxy transformer, through-hole, 0.625" X 0.625", 0.220" max height.
    Single epoxy transformer, through-hole, 0.625" X 0.625", 0.250" max height
    BTTC PART NO.
    TRANSFORMER CONFIGURATION
    Single epoxy transformer, surface mount, 0.625" X 0.625", 0.150" max height
    B-3229
    Single epoxy transformer, through hole, transformer coupled only, 0.500" X 0.350", 0.250" max height
    TABLE 3. BTTC TRANSFORMERS FOR USE WITH MINI-ACE
    Notes:
    1. DLP-7115 operates to +105°C max. All other transformers listed operate to +130°C max.
    相關PDF資料
    PDF描述
    BU-65179F0-800Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-65179F3-422Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-65179F3-472W 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-65179F3-492 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-65179G0-430L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    相關代理商/技術參數
    參數描述
    BU-65-2 功能描述:測試電夾 ALLIGATOR CLIP RED RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black
    BU65-2 制造商:MUELLER ELECTRIC CO. 功能描述: 制造商:Mueller Electric Company 功能描述:
    BU-652-0 功能描述:測試電夾 Black Small Safety A RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black
    BU6520KV 制造商:ROHM 制造商全稱:Rohm 功能描述:Video Encoders built-in Image Correction
    BU6520KV_10 制造商:ROHM 制造商全稱:Rohm 功能描述:Video Encoders built-in Image Correction