- 您現在的位置：買賣IC網 > PDF目錄369541 > BU-65178P3-112 MIL-STD-1553/ARINC Bus Controller/RTU PDF資料下載
參數資料
| 型號： | BU-65178P3-112 |
| 英文描述： | MIL-STD-1553/ARINC Bus Controller/RTU |
| 中文描述： | MIL-STD-1553/ARINC總線控制器/ RTU通訊 |
| 文件頁數： | 18/32頁 |
| 文件大?。?/td> | 833K |
| 代理商： | BU-65178P3-112 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
18
Data Device Corporation
www.ddc-web.com
BU-61559 Series
C-12/02-300
BUFFERED MODE
In the buffered mode (reference FIGURE 19), the processor data
and address buses connect directly to the corresponding buses
of the BU-61559. In this mode, the shared memory size is limit-
ed to the 8K X 16 of internal RAM. In the buffered mode, the
internal address latches and data buffers serve to isolate the
external processor address/data buses from the internal memo-
ry address/data buses.
The BU-61559 supports a direct interface to a multiplexed
processor bus by means of the input signal ADDR_LAT. When
ADDR_LAT is high, the latch/buffers for A15-A0 are in their trans-
parent mode. When ADDR_LAT is low, the latch/buffers for A15-
A0 are in their latched mode. In the buffered mode, the address
latch/buffers are directed inward for CPU accesses and are dis-
abled for 1553 accesses. The bidirectional data buffers are
directed inward for CPU write transfers, outward for CPU read
transfers, and are disabled for 1553 transfers.
FIGURE 18. BU-61559X1, BU-61559X2 INTERFACE TO 1553 BUS
NOTES for FIGURE 18:
(1) Shown for one of two redundant buses that interface to the BU-61559/60 Series hybrid.
(2) Transmitted voltage level on 1553 bus is 6 Vp-p min, 7 Vp-p nominal, 9 Vp-p max.
(3) Required tolerance on isolation resistors is 2%. Instantaneous power dissipation (when transmitting) is approximately 0.5 W (typ), 0.8 W (max).
(4) Transformer pin numbering is correct for DDC BUS-25679 or BUS-29854 transformer. For the Beta transformer (e.g., B-2203) or the QPL-21038-31 transformer (e.g.,
M21038/27-02), the winding sense and turns ratio are mechanically the same, but the pin numbering is reversed.Therefore, it is necessary to reverse pins 8 and 4 or
pins 7 and 5 in the diagram for the Beta or QPL transformers.
In the buffered mode, the output MEMENA-OUT
must
be con-
nected to the input MEMENA-IN.
TRANSPARENT MODE
The transparent mode (reference FIGURE 20) supports an inter-
face to up to 64K words of external shared RAM and/or to a
STANAG-3910 component set. In the transparent mode, the
memory control signals MEMENA-OUT, MEMOE, and MEMWR
are used to read and write data from/to external RAM.MEMENA-
OUT is the BU-61559's Chip Select (CS) output signal. For inter-
nal RAM accesses, the input MEMENA-IN should be asserted
low. When there is no ongoing memory access, or for accesses
to external RAM, MEMENA-IN should be presented as a logic 1.
In the transparent mode, the address buffers drive the CPU
address onto the internal memory bus for CPU transfers; for
1553 transfers, the internal memory address is asserted on the
external address bus. The data buffers are directed outward for
BU-61559X1
BU-61559X2
相關PDF資料 |
PDF描述 |
|---|---|
| BU-65178P3-122 | MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-65179F3-102 | MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-65179F3-112 | MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-65179F3-122 | MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-65179G3-102 | MIL-STD-1553/ARINC Bus Controller/RTU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU-65-2 | 功能描述:測試電夾 ALLIGATOR CLIP RED RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black |
| BU65-2 | 制造商:MUELLER ELECTRIC CO. 功能描述: 制造商:Mueller Electric Company 功能描述: |
| BU-652-0 | 功能描述:測試電夾 Black Small Safety A RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black |
| BU6520KV | 制造商:ROHM 制造商全稱:Rohm 功能描述:Video Encoders built-in Image Correction |
| BU6520KV_10 | 制造商:ROHM 制造商全稱:Rohm 功能描述:Video Encoders built-in Image Correction |
發布緊急采購，3分鐘左右您將得到回復。