• <dl id="48pth"><strike id="48pth"><wbr id="48pth"></wbr></strike></dl><thead id="48pth"><noframes id="48pth"></noframes></thead>
  • <big id="48pth"><s id="48pth"></s></big>
    <kbd id="48pth"><output id="48pth"><i id="48pth"></i></output></kbd>
    參數資料
    型號: BU-65171V2-160Q
    廠商: DATA DEVICE CORP
    元件分類: 微控制器/微處理器
    英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
    封裝: 1.900 X 1 INCH, 0.150 INCH HEIGHT, LOW PROFILE, CERAMIC, FP-70
    文件頁數: 3/44頁
    文件大?。?/td> 298K
    代理商: BU-65171V2-160Q
    BUS CONTROLLER (BC) ARCHITECTURE
    The BC protocol of the BU-61580 implements all MIL-STD-
    1553B message formats. Message format is programmable on a
    message-by-message basis by means of bits in the BC Control
    Word and the T/R bit of the Command Word for the respective
    message. The BC Control Word allows 1553 message format,
    1553A/B type RT, bus channel, self-test, and Status Word mask-
    ing to be specified on an individual message basis. In addition,
    automatic retries and/or interrupt requests may be enabled or
    disabled for individual messages. The BC performs all error
    checking required by MIL-STD-1553B. This includes validation of
    response time, sync type and sync encoding, Manchester II
    encoding, parity, bit count, word count, Status Word RT Address
    field, and various RT-to-RT transfer errors. The BU-61580's BC
    response timeout value is programmable with choices of 18, 22,
    50, and 130 s. The longer response timeout values enable
    operation over long buses and/or the use of repeaters.
    FIGURE 2 illustrates BC intermessage gap and frame timing.
    The BU-61580 may be programmed to process BC frames of up
    to 512 messages with no processor intervention. It is possible to
    program for either single frame or frame auto-repeat operation.
    In the auto-repeat mode, the frame repetition rate may be con-
    trolled either internally, using a programmable BC frame timer, or
    from an external trigger input. The internal BC frame time is pro-
    grammable up to 6.55 seconds in increments of 100 s. In addi-
    tion to BC frame time, intermessage gap time, measured from
    the start of the current message to the start of the subsequent
    message, is programmable on an individual message basis. The
    time between individual successive messages is programmable
    up to 65.5 ms, in increments of 1 s.
    BC MEMORY ORGANIZATION
    TABLE 25 illustrates a typical memory map for BC mode. It is
    important to note that the only fixed locations for the BU-61580
    in the Standard BC mode are for the two Stack Pointers (address
    locations 0100 (hex) and 0104) and for the two Message Count
    locations (0101 and 0105). Enabling the Frame Auto-Repeat
    mode will reserve four more memory locations for use in the
    Enhanced BC mode; these locations are for the two Initial Stack
    Pointers (address locations 102 (hex) and 106) and for the Initial
    Message Count locations (103 and 107). The user is free to
    locate the Stack and BC Message Blocks anywhere else within
    the 64K (4K internal) shared RAM address space.
    For simplicity of illustration, assume the allocation of the maxi-
    mum length of a BC message for each message block in the typ-
    ical BC memory map of TABLE 25. The maximum size of a BC
    message block is 38 words, for an RT-to-RT transfer of 32 Data
    Words (Control + 2 Commands + Loopback + 2 Status Words +
    32 Data Words). Note, however, that this example assumes the
    disabling of the 256-word boundaries.
    11
    MESSAGE NO. 1
    MESSAGE NO. 2
    MESSAGE NO. 1
    MESSAGE
    GAP TIME
    FOR MESSAGE NO. 1
    BC FRAME TIME
    INTERMESSAGE GAP TIME
    Stack B
    Not Used
    Message Block 93
    0F00-0FFF
    0EFC-0EFF
    0ED6-0EFB
    Initial Message Count A (see note)
    (Auto-Frame Repeat Mode)
    Message Block 2
    0154-0179
    Message Block 1
    012E-0153
    Message Block 0
    0108-012D
    Initial Message Count B (see note)
    (Auto-Frame Repeat Mode)
    0107
    Initail Stack Pointer B (see note)
    (Auto-Frame Repeat Mode)
    0106
    Message Count B
    0105
    Stack Pointer B
    0104
    Initial Stack Pointer A (see note) (Auto-Frame Repeat
    Mode)
    0102
    Message Count A (fixed location)
    0101
    Stack Pointer A (fixed location)
    Stack A
    DESCRIPTION
    ADDRESS
    (HEX)
    0103
    FIGURE 2. BC MESSAGE GAP AND FRAME TIMING
    Note: Used only in the Enhanced BC mode with Frame Auto-Repeat enabled.
    0000-00FF
    TABLE 25. TYPICAL BC MEMORY ORGANIZATION
    (SHOWN FOR 4K RAM)
    0100
    相關PDF資料
    PDF描述
    BU-65171V3-132K 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
    BU-65171V5-120Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
    BU-65171V5-160Z 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
    BU-65171V6-180L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
    BU-65178G0-170Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    相關代理商/技術參數
    參數描述
    BU65171V3100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU65171V3110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU65171V3120 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU65171V3300 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU-65-2 功能描述:測試電夾 ALLIGATOR CLIP RED RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black