- 您現在的位置：買賣IC網 > PDF目錄256153 > BU-61843F3-732Z (DATA DEVICE CORP) 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 PDF資料下載
參數資料
| 型號： | BU-61843F3-732Z |
| 廠商： | DATA DEVICE CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| 封裝： | 1 X 1 INCH, 0.155 INCH HEIGHT, CERAMIC, FP-72 |
| 文件頁數： | 44/60頁 |
| 文件大小： | 700K |
| 代理商： | BU-61843F3-732Z |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
49
Data Device Corporation
www.ddc-web.com
BU-6174X/6184X/6186X
Rev. C
UPADDREN
(BU-6174X,
BU-6184X only)
For BU-61864/61865FX/GX, this pin signal is +5V-RAM and MUST be connected to +5V.
For BU-6174X and 6184X, this signal is used to control the function of the upper 4 address inputs (A15-
A12). For these versions of Enhanced Mini-ACE, if UPADDREN is connected to logic "1", then these four
signals operate as address lines A15-A12.
For BU-6184X/6174X, if UPADDREN is connected to logic "0", then A15 and A14 function as CLK_SEL_1
and CLK_SEL_0 respectively; A13 MUST be connected to Vcc-LOGIC (+5V or +3.3V); and A12 functions
as RTBOOT.
26
INT (O)
Interrupt Request output. If the LEVEL/PULSE interrupt bit (bit 3) of Configuration Register #2 is logic "0",
a negative pulse of approximately 500ns in width is output on INT to signal an interrupt request.
If LEVEL/PULSE is high, a low level interrupt request output will be asserted on INT. The level interrupt
will be cleared (high) after either: (1) The processor writes a value of logic "1" to INTERRUPT RESET, bit
2 of the Start/Reset Register; or (2) If bit 4 of Configuration Register #2, INTERRUPT STATUS AUTO-
CLEAR is logic "1", then it will only be necessary to read the Interrupt Status Register (#1 and/or #2) that
is requesting an interrupt that has been enabled by the corresponding Interrupt Mask Register. However,
for the case where both Interrupt Status Register #1 and Interrupt Status Register #2 have bits set reflect-
ing interrupt events, it will be necessary to read both interrupt status registers in order to clear INT.
57
INCMD (O) /
MCRST (O)
In-command or Mode Code Reset. The function of this pin is controlled by bit 0 of Configuration Register
#7, MODE CODE RESET/INCMD SELECT.
If this register bit is logic "0" (default), INCMD will be active on this pin. For BC, RT, or Selective Message
Monitor modes, INCMD is asserted low whenever a message is being processed by the Enhanced Mini-
ACE. In Word Monitor mode, INCMD will be asserted low for as long as the monitor is online.
For RT mode, if MODE CODE RESET/INCMD SELECT is programmed to logic "1", MCRST will be
active. In this case, MCRST will be asserted low for two clock cycles following receipt of a Reset remote
terminal mode command.
In BC or Monitor modes, if MODE CODE RESET/INCMD SELECT is logic "1", this signal is inoperative;
i.e., in this case, it will always output a value of logic "1".
25
TABLE 53. MISCELLANEOUS
SIGNAL NAME
DESCRIPTION
PIN
BU-6186XFX/GX
BU-6184XFX/GX
BU-6174XFX/GX
相關PDF資料 |
PDF描述 |
|---|---|
| BU-61843F3-800Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61843F4-320Y | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61843F4-400Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61843F4-420Z | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61843F4-730K | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU-61843F4-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| BU-61843F4-110 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| BU-61843G3-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| BU-61843G3-110 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| BU-61843G4-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
發布緊急采購，3分鐘左右您將得到回復。