<center id="drv4a"><acronym id="drv4a"><i id="drv4a"></i></acronym></center>
    <ins id="drv4a"></ins>
    參數資料
    型號: BU-61583G0-801W
    廠商: DATA DEVICE CORP
    元件分類: 微控制器/微處理器
    英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    封裝: CERAMIC, GULL LEAD, 70 PIN
    文件頁數: 30/48頁
    文件大?。?/td> 378K
    代理商: BU-61583G0-801W
    36
    Data Device Corporation
    www.ddc-web.com
    BU-61582
    G-08/02-250
    INTERFACE TO MIL-STD-1553 BUS
    FIGURE 18 illustrates the interface from the various versions of
    the SP'ACE series terminals to a 1553 bus. The figure also indi-
    cates connections for both direct (short stub) and transformer
    (long stub) coupling, plus the peak-to-peak voltage levels that
    appear at various points (when transmitting).
    TABLE 33 lists the characteristics of the required isolation trans-
    formers for the various SP'ACE terminals, the DDC and Beta
    Transformer Technology Corporation corresponding part num-
    ber, and the MIL (DESC) drawing number (if applicable). Beta
    Transformer Technology is a direct subsidiary of DDC.
    For both coupling configurations, the isolation transformer is the
    transformer that interfaces directly to the SP'ACE component.
    For the transformer (long stub) coupling configuration, the trans-
    former that interfaces the stub to the bus is the coupling trans-
    former. The turns ratio of the isolation transformer varies,
    depending upon the peak-to-peak output voltage of the specific
    SP'ACE terminal.
    The transmitter voltage of each model of the BU-61582 varies
    directly as a function of the power supply voltage. The turns
    ratios of the respective transformers will yield a secondary volt-
    age of approximately 28 volts peak-to-peak on the outer taps
    (used for direct coupling) and 20 volts peak-to-peak on the inner
    taps (used for stub coupling).
    In accordance with MIL-STD-1553B, the turns ratio of the cou-
    pling transformer is 1.0 to 1.4. Both coupling configurations
    require an isolation resistor to be in series with each leg con-
    necting to the 1553 bus; this protects the bus against short cir-
    cuit conditions in the transformers, stubs, or terminal compo-
    nents.
    Notes for TABLE 33 and FIGURE 18:
    (1) Shown for one of two redundant buses that interface to the BU-
    61582.
    (2) Transmitted voltage level on 1553 bus is 6 Vp-p min, 7 Vp-p nomi-
    nal, 9 Vp-p max.
    (3) Required tolerance on isolation resistors is 2%. Instantaneous
    power dissipation (when transmitting) is approximately 0.5 W (typ),
    0.8 W (max).
    (4) Transformer pin numbering is correct for the DDC (e.g., BUS-
    25679) transformers. For the Beta transformers (e.g., B-2203) or
    the QPL-21038-31 transformers (e.g., M21038/27-02), the winding
    sense and turns ratio are mechanically the same, but with reversed
    pin numbering; therefore, it is necessary to reverse pins 8 and 4 or
    pins 7 and 5 for the Beta or QPL transformers (Note: DDC trans-
    former part numbers begin with a BUS- prefix, while Beta trans-
    former part numbers begin with a B- prefix).
    (5) The B-2204, B-2388, and B-2344 transformers have a slightly differ-
    ent turns ratio on the direct coupled taps then the turns ratio of the
    BUS-29854 direct coupled taps. They do, however, have the same
    transformer coupled ratio. For transformer coupled applications,
    either transformer may be used. The transceiver in the BU-61582
    was designed to work with a 1:0.83 ratio for direct coupled applica-
    tions. For direct coupled applications, the 1.20:1 turns ration is rec-
    ommended, but the 1.25:1 may be used. The 1.25:1 turns ratio will
    result in a slightly lower transmitter amplitude. (Approximately 3.6%
    lower) and a slight shift in the SP'ACE's receiver threshold.
    TABLE 33. ISOLATION TRANSFORMER GUIDE
    B-2388
    M21038/27
    -13,
    B-2334,
    M21038/27
    -18
    BUS-29854
    1.20:1
    SURFACE
    MOUNT
    B-2387
    M21038/27
    -12,
    M21038/27
    -17
    LPB-5002
    LPB-5009
    LPB-6002
    LPB-6009
    LPB-5001
    LPB-5008
    LPB-6001
    LPB-6008
    RECOMMENDED XFORMER
    PLUG-IN
    BUS-25679,
    B-2203,
    M21038/27
    -02
    B-2204,
    M21038/27
    -03
    XFORMER
    COUPLED
    2:1
    1:0.6
    1.25:1
    (Note 5)
    BU-61582X2
    1.41:1
    BU-61582X1
    DIRECT
    COUPLED
    SP’ACE PART
    NUMBER
    TURNS RATIO
    相關PDF資料
    PDF描述
    BU-61583G0-801Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    BU-61583G0-890 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    BU-61583G0-891Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    BU-61583G1-100L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    BU-61583G1-100Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70
    相關代理商/技術參數
    參數描述
    BU-61585 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |ACE
    BU-61586 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |ACE
    BU61586V6-300 制造商:DDC 功能描述:MIL-STD-1553/ARINC BUS CONTROLLER/RTU, 70 Pin, Flat Pack
    BU-61588 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MINIATURE ADVANCED COMMUNICATION ENGINE (MINI-ACE) AND MINI-ACE PLUS
    BU-61588F0 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MINIATURE ADVANCED COMMUNICATION ENGINE (MINI-ACE) AND MINI-ACE PLUS