參數資料
      型號: BU-61583F6-471K
      廠商: DATA DEVICE CORP
      元件分類: 微控制器/微處理器
      英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      封裝: CERAMIC, DFP-70
      文件頁數: 30/48頁
      文件大?。?/td> 378K
      代理商: BU-61583F6-471K
      36
      Data Device Corporation
      www.ddc-web.com
      BU-61582
      G-08/02-250
      INTERFACE TO MIL-STD-1553 BUS
      FIGURE 18 illustrates the interface from the various versions of
      the SP'ACE series terminals to a 1553 bus. The figure also indi-
      cates connections for both direct (short stub) and transformer
      (long stub) coupling, plus the peak-to-peak voltage levels that
      appear at various points (when transmitting).
      TABLE 33 lists the characteristics of the required isolation trans-
      formers for the various SP'ACE terminals, the DDC and Beta
      Transformer Technology Corporation corresponding part num-
      ber, and the MIL (DESC) drawing number (if applicable). Beta
      Transformer Technology is a direct subsidiary of DDC.
      For both coupling configurations, the isolation transformer is the
      transformer that interfaces directly to the SP'ACE component.
      For the transformer (long stub) coupling configuration, the trans-
      former that interfaces the stub to the bus is the coupling trans-
      former. The turns ratio of the isolation transformer varies,
      depending upon the peak-to-peak output voltage of the specific
      SP'ACE terminal.
      The transmitter voltage of each model of the BU-61582 varies
      directly as a function of the power supply voltage. The turns
      ratios of the respective transformers will yield a secondary volt-
      age of approximately 28 volts peak-to-peak on the outer taps
      (used for direct coupling) and 20 volts peak-to-peak on the inner
      taps (used for stub coupling).
      In accordance with MIL-STD-1553B, the turns ratio of the cou-
      pling transformer is 1.0 to 1.4. Both coupling configurations
      require an isolation resistor to be in series with each leg con-
      necting to the 1553 bus; this protects the bus against short cir-
      cuit conditions in the transformers, stubs, or terminal compo-
      nents.
      Notes for TABLE 33 and FIGURE 18:
      (1) Shown for one of two redundant buses that interface to the BU-
      61582.
      (2) Transmitted voltage level on 1553 bus is 6 Vp-p min, 7 Vp-p nomi-
      nal, 9 Vp-p max.
      (3) Required tolerance on isolation resistors is 2%. Instantaneous
      power dissipation (when transmitting) is approximately 0.5 W (typ),
      0.8 W (max).
      (4) Transformer pin numbering is correct for the DDC (e.g., BUS-
      25679) transformers. For the Beta transformers (e.g., B-2203) or
      the QPL-21038-31 transformers (e.g., M21038/27-02), the winding
      sense and turns ratio are mechanically the same, but with reversed
      pin numbering; therefore, it is necessary to reverse pins 8 and 4 or
      pins 7 and 5 for the Beta or QPL transformers (Note: DDC trans-
      former part numbers begin with a BUS- prefix, while Beta trans-
      former part numbers begin with a B- prefix).
      (5) The B-2204, B-2388, and B-2344 transformers have a slightly differ-
      ent turns ratio on the direct coupled taps then the turns ratio of the
      BUS-29854 direct coupled taps. They do, however, have the same
      transformer coupled ratio. For transformer coupled applications,
      either transformer may be used. The transceiver in the BU-61582
      was designed to work with a 1:0.83 ratio for direct coupled applica-
      tions. For direct coupled applications, the 1.20:1 turns ration is rec-
      ommended, but the 1.25:1 may be used. The 1.25:1 turns ratio will
      result in a slightly lower transmitter amplitude. (Approximately 3.6%
      lower) and a slight shift in the SP'ACE's receiver threshold.
      TABLE 33. ISOLATION TRANSFORMER GUIDE
      B-2388
      M21038/27
      -13,
      B-2334,
      M21038/27
      -18
      BUS-29854
      1.20:1
      SURFACE
      MOUNT
      B-2387
      M21038/27
      -12,
      M21038/27
      -17
      LPB-5002
      LPB-5009
      LPB-6002
      LPB-6009
      LPB-5001
      LPB-5008
      LPB-6001
      LPB-6008
      RECOMMENDED XFORMER
      PLUG-IN
      BUS-25679,
      B-2203,
      M21038/27
      -02
      B-2204,
      M21038/27
      -03
      XFORMER
      COUPLED
      2:1
      1:0.6
      1.25:1
      (Note 5)
      BU-61582X2
      1.41:1
      BU-61582X1
      DIRECT
      COUPLED
      SP’ACE PART
      NUMBER
      TURNS RATIO
      相關PDF資料
      PDF描述
      BU-61583F6-471Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61583F6-480L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61583F6-480Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61583F6-481L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61583F6-481Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      相關代理商/技術參數
      參數描述
      BU-61585 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |ACE
      BU-61586 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |ACE
      BU61586V6-300 制造商:DDC 功能描述:MIL-STD-1553/ARINC BUS CONTROLLER/RTU, 70 Pin, Flat Pack
      BU-61588 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MINIATURE ADVANCED COMMUNICATION ENGINE (MINI-ACE) AND MINI-ACE PLUS
      BU-61588F0 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MINIATURE ADVANCED COMMUNICATION ENGINE (MINI-ACE) AND MINI-ACE PLUS