- 您現在的位置：買賣IC網 > PDF目錄166537 > BU-61580V6-420Y (DATA DEVICE CORP) 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70 PDF資料下載
參數資料
| 型號： | BU-61580V6-420Y |
| 廠商： | DATA DEVICE CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70 |
| 封裝： | 48.30 X 25.40 MM, 3.81 MM HEIGHT, FP-70 |
| 文件頁數： | 3/44頁 |
| 文件大?。?/td> | 563K |
| 代理商： | BU-61580V6-420Y |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
11
Data Device Corporation
www.ddc-web.com
BU-65170/61580/61585
H1 web-09/02-0
BUS CONTROLLER (BC) ARCHITECTURE
The BC protocol of the BU-61580 implements all MIL-STD-
1553B message formats. Message format is programmable on a
message-by-message basis by means of bits in the BC Control
Word and the T/R bit of the Command Word for the respective
message. The BC Control Word allows 1553 message format,
1553A/B type RT, bus channel, self-test, and Status Word mask-
ing to be specified on an individual message basis. In addition,
automatic retries and/or interrupt requests may be enabled or
disabled for individual messages. The BC performs all error
checking required by MIL-STD-1553B. This includes validation of
response time, sync type and sync encoding, Manchester II
encoding, parity, bit count, word count, Status Word RT Address
field, and various RT-to-RT transfer errors. The BU-61580's BC
response timeout value is programmable with choices of 18, 22,
50, and 130 s. The longer response timeout values enable
operation over long buses and/or the use of repeaters.
FIGURE 2 illustrates BC intermessage gap and frame timing.
The BU-61580 may be programmed to process BC frames of up
to 512 messages with no processor intervention. It is possible to
program for either single frame or frame auto-repeat operation.
In the auto-repeat mode, the frame repetition rate may be con-
trolled either internally, using a programmable BC frame timer, or
from an external trigger input. The internal BC frame time is pro-
grammable up to 6.55 seconds in increments of 100 s. In addi-
tion to BC frame time, intermessage gap time, measured from
the start of the current message to the start of the subsequent
message, is programmable on an individual message basis. The
time between individual successive messages is programmable
up to 65.5 ms, in increments of 1 s.
BC MEMORY ORGANIZATION
TABLE 25 illustrates a typical memory map for BC mode. It is
important to note that the only fixed locations for the BU-61580
in the Standard BC mode are for the two Stack Pointers (address
locations 0100 (hex) and 0104) and for the two Message Count
locations (0101 and 0105). Enabling the Frame Auto-Repeat
mode will reserve four more memory locations for use in the
Enhanced BC mode; these locations are for the two Initial Stack
Pointers (address locations 102 (hex) and 106) and for the Initial
Message Count locations (103 and 107). The user is free to
locate the Stack and BC Message Blocks anywhere else within
the 64K (4K internal) shared RAM address space.
For simplicity of illustration, assume the allocation of the maxi-
mum length of a BC message for each message block in the typ-
ical BC memory map of TABLE 25. The maximum size of a BC
message block is 38 words, for an RT-to-RT transfer of 32 Data
Words (Control + 2 Commands + Loopback + 2 Status Words +
32 Data Words). Note, however, that this example assumes the
disabling of the 256-word boundaries.
MESSAGE NO. 1
MESSAGE NO. 2
MESSAGE NO. 1
MESSAGE
GAP TIME
FOR MESSAGE NO. 1
BC FRAME TIME
INTERMESSAGE GAP TIME
Stack B
Not Used
Message Block 93
0F00-0FFF
0EFC-0EFF
0ED6-0EFB
Initial Message Count A (see note)
(Auto-Frame Repeat Mode)
Message Block 2
0154-0179
Message Block 1
012E-0153
Message Block 0
0108-012D
Initial Message Count B (see note)
(Auto-Frame Repeat Mode)
0107
Initial Stack Pointer B (see note)
(Auto-Frame Repeat Mode)
0106
Message Count B
0105
Stack Pointer B
0104
Initial Stack Pointer A (see note) (Auto-Frame Repeat
Mode)
0102
Message Count A (fixed location)
0101
Stack Pointer A (fixed location)
Stack A
DESCRIPTION
ADDRESS
(HEX)
0103
FIGURE 2. BC MESSAGE GAP AND FRAME TIMING
Note: Used only in the Enhanced BC mode with Frame Auto-Repeat enabled.
0000-00FF
TABLE 25. TYPICAL BC MEMORY ORGANIZATION
(SHOWN FOR 4K RAM)
0100
相關PDF資料 |
PDF描述 |
|---|---|
| BU-61580V6-500Y | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70 |
| BU-61580V6-820Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70 |
| BU-61585G1-220L | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70 |
| BU-61585G1-820W | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70 |
| BU-61585G2-400L | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDSO70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU-61581 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |ACE |
| BU61581F6-300 | 制造商:DDC 功能描述:61581F6-300 |
| BU-61581G1-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-61581G1-110 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU |
| BU-61581G1-120 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU |
發布緊急采購，3分鐘左右您將得到回復。