參數資料
型號: AU-1293-140
廠商: MITEQ INC
元件分類: 放大器
英文描述: 100 MHz - 180 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER
文件頁數: 22/25頁
文件大?。?/td> 1906K
代理商: AU-1293-140
5
BIPOLAR AMPLIFIERS
INPUT AND OUTPUT VSWR
Most RF and microwave systems are designed
around a 50
impedance system. An amplifier's
impedance is designed to be as close as possible to
50
; however, this is not always possible, especially
when attempting to simultaneously achieve a good
noise figure. The VSWR of an amplifier is a measure
of an amplifier’s actual impedance (Z) with respect to
the desired impedance (Zo) in most cases 50 .
The VSWR is derived from the reflection coefficient
ρ,
where
ρ is a ratio of the normalized impedance:
VSWR is "measured" with either a scalar or vector
network analyzer by analyzing the incident power and
the reflected power at both ports of the device to
determine the reflection coefficients which in turn are
converted and displayed as VSWR. The ratio of the
reflected power to the incident power is also known as
the return loss.
SUPPLY VOLTAGE AND
CURRENT CONSUMPTION
All standard models are internally voltage regulated.
Most amplifiers are specified for +15 VDC operation
but may be safely operated at +30 V. Many models
employ an internal 9-volt regulator, permitting opera-
tion over a range of +11 to +30 VDC. Operation above
+15 V may require a heatsink for some medium
power amplifiers. All models are reverse voltage pro-
tected. The use of a regulator allows normal operation
even in the presence of power supply variations, as
long as the minimum voltage is above the drop-out
voltage of the regulator plus the 0.7 V drop across the
reverse polarity protection diode. An amplifier with an
internal 8-volt regulator requires a minimum voltage of
about +10.7 V. Please ask about your specific model.
ADDITIONAL SPECIFICATIONS
In addition to the electrical specifications included for
most of the models within this catalog, there are addi-
tional specifications which are useful to the engineer
designing around stringent system requirements:
Gain Variation vs. Temperature
Overall Gain Window
Intercept Point
Dynamic Range
Harmonic Suppression
Reverse Isolation
Phase and Amplitude Matching and Tracking
Phase Linearity
Recovery from Saturation
GAIN VARIATION VS. TEMPERATURE
Gain variation versus temperature defines the maxi-
mum allowable variation of the linear gain due to tem-
perature at any discrete frequency. As a result, this
parameter does not account for drift over frequency.
Gain variation versus temperature is measured by
performing swept gain measurements at the specified
temperature extremes and comparing the deviations
between the two sweeps at each frequency to deter-
mine the greatest change. When a ± value is used,
then the delta is taken at both temperature extremes
with respect to room temperature (+23°C).
SPECIFICATION DEFINITIONS (CONT.)
Maximum Variation vs. Temperature
Operating Frequency Range
(Measured at room, hot and cold)
cold
room
Gain
F Low
F High
hot
ρ = Z - Zo
Z + Zo
and:
VSWR =
1 +
ρ
1 -
ρ
相關PDF資料
PDF描述
AM-3A-000515 5 MHz - 1500 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER
AU-1241-70 50 MHz - 90 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER
AUP-1479 5 MHz - 300 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER
AM-1571-140 100 MHz - 180 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER
AM-1571-70 50 MHz - 90 MHz RF/MICROWAVE NARROW BAND LOW POWER AMPLIFIER
相關代理商/技術參數
參數描述
AU-13.500MBE-T 功能描述:標準時鐘振蕩器 13.500MHz 3.3Volt 50ppm -40C to 85C RoHS:否 制造商:AVX 產品:Standard Clock Oscillators 封裝 / 箱體:7 mm x 5 mm 頻率:75 MHz 頻率穩定性:50 PPM 電源電壓:2.5 V 負載電容: 端接類型:SMD/SMT 最小工作溫度:0 C 最大工作溫度:+ 70 C 輸出格式:LVDS 尺寸: 封裝:Reel 系列:
AU1310-533MBDA2 功能描述:AU1310 A2 IC SD MEDIA PROCESSOR 制造商:broadcom limited 系列:* 零件狀態:在售 標準包裝:60
AU1320 制造商:Abus 功能描述:Bulk
AU1340-533MBDA2 功能描述:AU1340 A2 IC SD MEDIA PROCESSOR 制造商:broadcom limited 系列:* 零件狀態:在售 標準包裝:60
AU13-4213-06 制造商:FLOWLINE 功能描述:Switch-Pak, Level, Ultrasonic, PP, Controller w/Strobe, 2" NPT, 6"