- 您現在的位置：買賣IC網 > PDF目錄1904 > ATA6620N-TAQY (Atmel)TXRX LIN BUS W/VREG SO-8 PDF資料下載
參數資料
| 型號： | ATA6620N-TAQY |
| 廠商： | Atmel |
| 文件頁數： | 19/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | TXRX LIN BUS W/VREG SO-8 |
| 產品變化通告： | ATA6620N-TAxY Obsolescence 03/Feb/2012 |
| 標準包裝： | 4,000 |
| 類型： | 收發器 |
| 規程： | LIN |
| 電源電壓： | 5 V ~ 18 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
6
4850I–AUTO–09/09
ATA6620N
4.2
Modes of Reduced Current Consumption
4.2.1
Silent Mode
A falling edge at EN while TXD is high switches the IC into Silent mode. The TXD Signal has to
be logic high during the Mode Select window (see Figure 4-2 on page 6). For EN and TXD either
two independent outputs can be used, or two outputs from the same microcontroller port; in the
second case, the mode change is only one command.
In Silent mode the transmission path is disabled. Supply current from V
Batt is typically
I
VSsi = 40 A with no load at the VCC regulator.
The overall supply current from V
Batt is the result of 40 A plus the VCC regulator output current
I
VCCs.
The 5V regulator is in low tolerance mode (4.65V to 5.35V) and can source up to 50 mA. In
Silent mode the internal slave termination between pin LIN and pin VS is disabled to minimize
the power dissipation in case pin LIN is short-circuited to GND. Only a weak pull-up current (typ-
ically 10 A) between pin LIN and pin VS is present.
The Silent mode voltage is sufficient to run an external microcontroller on the ECU, for example
in Power Down mode. The undervoltage reset is V
CCthS < 4.4V. If an undervoltage condition
occurs, NRES is switched to low and the ATA6620N changes state to Pre-normal mode.
A falling edge at pin LIN followed by a dominant bus level maintained for a certain time period
(t
bus) results in a remote wake-up request. The device switches from Silent mode to Pre-normal
mode, then the internal LIN slave termination resistor is switched on. The remote wake-up
request is indicated by a low level at pin RXD to interrupt the microcontroller and a high level at
pin TXD (see Figure 4-3 on page 7).
With EN high, ATA6620N switches directly from Silent- via Pre-normal to Normal mode.
Figure 4-2.
Switch to Silent Mode
EN
td = 3.2 s
TXD
Silent Mode
VCC
LIN
Mode select window
NRES
Normal Mode
LIN switches directly to recessive mode
Delay time silent mode
td_sleep = maximum 20 s
相關PDF資料 |
PDF描述 |
|---|---|
| ATA6661-TAQJ 19 | TXRX LIN 2.0 3.3V/5V 8SOIC |
| ATA6670-FFQW | IC TXRX LIN DUAL 14VDFN |
| ATAM893T-TKSYD | IC MCU FLASH 4K MTP 20SSOP |
| ATF1500ABV-15JI | IC CPLD 15NS LOW VOLT PLCC |
| ATF1500AL-20JI | IC CPLD 20NS LOW POW 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TASY | 功能描述:射頻無線雜項 LIN SBC RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| ATA6620-TAQY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
| ATA6620-TASY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
發布緊急采購，3分鐘左右您將得到回復。