- 您現在的位置：買賣IC網 > PDF目錄362506 > AT88SC0808C-ME-XX EEPROM PDF資料下載
參數資料
| 型號： | AT88SC0808C-ME-XX |
| 元件分類： | EEPROM |
| 英文描述： | EEPROM |
| 中文描述： | EEPROM的 |
| 文件頁數： | 5/13頁 |
| 文件大?。?/td> | 141K |
| 代理商： | AT88SC0808C-ME-XX |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁
5
AT88SC0104C
2021BS–SMEM–10/02
Protocol Selection
The AT88SC0104C is compatible with two different communication protocols: asynchro-
nous T = 0 as defined by ISO 7816-3 or synchronous two-wire protocol. The power-up
sequence determines which of the two protocols will be used.
Asynchronous
T = 0 Protocol
The power-up sequence complies with ISO 7816-3 for a cold reset.
V
CC
goes high; RST, I/O-SDA and CLK-SCL are low.
Set I/O-SDA in receive mode.
Provide a clock signal to CLK-SCL.
RST goes high after 400 clock cycles.
The device will respond with a 64-bit ATR code, including historical bytes to indicate the
memory density within the CryptoMemory family. Once the asynchronous mode has
been selected, it is not possible to switch to the synchronous mode without powering off
the device.
Figure 2.
Asynchronous T = 0 Protocol
Synchronous
Two-wire Protocol
The synchronous mode is the default after powering up V
CC
due to the internal pull-up
on RST.
Power-up V
CC
, RST goes high also.
After stable V
CC
, CLK-SCL and I/O-SDA may be driven.
Figure 3.
Synchronous Two-wire Protocol
Note:
Four clock pulses must be sent before the first command is issued.
Vcc
I/O-SDA
RST
CLK-SCL
ATR
Vcc
I/O-SDA
RST
CLK-SCL
1
2
3
4
相關PDF資料 |
PDF描述 |
|---|---|
| AT88SC0808C-ME-XX-2.7 | EEPROM |
| AT88SC0808C-MN-XX | EEPROM |
| AT88SC0808C-MN-XX-2.7 | EEPROM |
| AT88SC0808C-MP-XX | EEPROM |
| AT88SC0808C-MP-XX-2.7 | EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT88SC0808C-ME-XX-2.7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
| AT88SC0808C-MJ | 功能描述:電可擦除可編程只讀存儲器 CRYPTO Memory 1Kbit, 4zones RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| AT88SC0808C-MJTG | 功能描述:電可擦除可編程只讀存儲器 CRYPTOMEMORY 8-KBIT 8 ZONE RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| AT88SC0808C-MN-XX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
| AT88SC0808C-MN-XX-2.7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
發布緊急采購，3分鐘左右您將得到回復。