- 您現在的位置：買賣IC網 > PDF目錄381308 > AS2702-20 (AUSTRIAMICROSYSTEMS AG) Actuator sensor interface; Package Type: SOIC-20 PDF資料下載
參數資料
| 型號： | AS2702-20 |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | 其它接口 |
| 英文描述： | Actuator sensor interface; Package Type: SOIC-20 |
| 中文描述： | SPECIALTY INTERFACE CIRCUIT, PDSO20 |
| 封裝： | SOIC-20 |
| 文件頁數： | 8/13頁 |
| 文件大?。?/td> | 134K |
| 代理商： | AS2702-20 |
AS2702 – AS-Interface Slave IC
Revision 1.3, 21-Aug-08
Page 8 of 13
depending on the IO-configuration code, written and stored in the slave device.
The timing of the data transfer is presented in Figure 4.
Strobe signal PSTBn flags and governs the data transfer as follows:
a)
parameter port is set ‘output’:
output data become valid upon the HL-edge of the strobe and will remain so until the next HL-edge, hence during the entire
strobe cycle;
b) parameter port is set ‘input’:
input data to be valid within a specific time window relative to the HL-edge of the strobe, after completion of the strobe’s L-
phase.
Output data as per a) could be easily latched with the LH-edge of strobe PSTBn, if at all necessary.
output, or
input
Parameter out
Data in
t
STB
t
PSTBn
+ t
OUTOFF
t
PSTBn
t
INPmin
t
INPmax
Px
Px
PSTBn
Parameter out
Figure 4
Timing of data transfer at parameter port P3, …, P0 relative to strobe PSTBn
The following table specifies the timing parameters relating to Figure 4:
Symbol
Parameter
tSTB
Delay PSTBn HL-edge to Px output data valid
tPSTBn
PSTBn strobe width
tINP
Input data valid time window
Min
6
10.5
Max
1.5
6.8
12.5
Unit
μs
μs
μs
Note
1
2
Notes:
1
2
Pulse width depends substantially on value of external pull-up resistor
Timing reference is PSTBn HL-edge.
Applies only to parameter port set to 'input' operation
The dc-parameters of the parameter port pins P3, …, P0 are specified as follows:
Symbol
Parameter
IOUTLO
Sink current @ output L
IOUTHI
Leakage current @ output off
IOUTHI7
Leakage current @ output off; pull-up current source off
IINLO
Input current @ VIN = 1V
Min
10
-10
-1
-5
Max
10
1
-20
Unit Note
mA VOUT = 1V
μA VOUT = 5V
μA VOUT = 5V; IO-conf. = 7
μA 1
相關PDF資料 |
PDF描述 |
|---|---|
| AS2702 | AS-Interface Slave IC |
| AS2702-16T | AS-Interface Slave IC |
| AS2702-20T | AS-Interface Slave IC |
| AS29F010-150TC | 5V 128K x 8 CMOS FLASH EEPROM |
| AS29F010-120TC | 5V 128K x 8 CMOS FLASH EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS2702-20T | 制造商:ams 功能描述:IC INDUSTRIAL BUS 20-SOIC |
| AS2702-20-T | 功能描述:異步串行接口 - ASI RoHS:否 制造商:ams |
| AS2702TR-20 | 制造商:ams 功能描述: |
| AS2710U600 Ohm0.5DB | 制造商:Teikoku Tsushin Kogyo 功能描述: |
| AS2710U6001/2DB | 制造商:Teikoku Tsushin Kogyo 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。